Efergy EMax Smart Home TX Installation Manual

EMax Smart Home TX
Installation guide
www.efergy.com
Need help?
http://www.fergy.com/support
customercare@efergy.com
Sales: sales@efergy.com
SAFETY INFORMATION
When installing the Efergy EMax Smart Home Energy Monitor you
Should find that everything is straight-forward. However, there are
number of important health and safety issues which you need to be
aware of:
Voltages dangerous to human health are involved in the installation of
Efergy EMax Energy Monitor. Follow all warnings provided in this
guideline to ensure your own safety.
Do not touch sensors clip onto the supply cables inside the main elec-
trical panel. Do not carry out this installation if under the influence of
alcohol or drugs.
Do not use Efergy EMax Smart Home Energy Monitor transmitter in any
manner other than specified in this installation guide.
Do not attempt to open, disassemble, or repair any ot the components
of the transmitter.
Do not leave in direct sunlight or near sources of heat.
Do not install the transmitter in environment with explosive gas or
vapors; not in damp or wet environments; nor in direct sunlight; nor
where temperatures are consistently out of specification.
Ensure the transmitter does not have power during any handling,
including installation and disassembly.
During the installation you may also need:
ELECTRICAL SPECIFICATION
Model: EMSHTX
Input: 90-250V AC , 1Ø , 50/60Hz, 0.014A
Power: 3W
Wireless: 433.5MHz
。 。
Operation: -40 C to 50 C , 0-82% RH, Indoor used only
cable length: 1m
THE HARDWARE
SMA antenna Port
1-4 60A CT input port
A-C 120/200A CT input port
reset Reset button
power cord Brown : to Live; Blue : to Neutral
LED Green: System ; Blue: CT configure
OPERATIONS
RESET
Hold reset button for 5s until GREEN LED is flashing.
Configure Main's CT
Hold "reset" button for 10s until BLUE LED light on.
Check Main's CT configuration
Single press reset button to check BLUE LED status
Solid in BLUE for 5 seconds--------200A configured
Flashing in BLUE for 5 seconds----120A configured
AMBINENT INDICATION
Connected: Solid GREEN
Connecting: Flashing GREEN
200A CT configured: Solid BLUE
120A CT configured: FLASHING BLUE
RESET for Paring: Flashing in GREEN &BLUE
EFERGY RECOMMENDS THAT INSTALLATION IS
CARRIED OUT BY A QUALIFIED ELECTRICIAN