SurfaceMaxx SGY-PWA83A Instruction Sheet

Foam Cannon Notes:
With the sprayer removed from the bottle, fill the bottle with warm water and soap made for foam cannons (not
included). Use recommended water to soap ratio on the soap label.
ASSEMBLY INSTRUCTIONS
1. Attach the bottle to the sprayer. Turn the sprayer
"clockwise" until tight. Do not overtighten.
2. Connect the Foam Cannon to the quick connect
fitting on your spray gun or wand.
Note: Pressure washer should be turned off during
connection or the spray gun trigger should be in the
locked position.
OPERATING INSTRUCTIONS
1. The SurfaceMaxx Foam Cannon features a 24 oz. bottle. The draw ratio during use is approximately 1:10
detergent to water. For best results, foam cannon soap is recommended.
2. The air intake knob adjusts the amount of foam,
turn counterclockwise for more foam and turn
clockwise for less foam.
3. With the pressure washer on, pull the trigger on
spray gun to spray foam.
Note: Do a test shot away from the object you are
spraying to ensure the foam cannon is attached
properly and you are getting the spray pattern you
want.
CAUTION:
Do not point the foam cannon at people or animals
as it can cause injury.
INSTRUCTION SHEET
1
Pressure Washer
Foam Cannon
MODEL #SGY-PWA83A
1
2
1
www.surfacemaxx.com