Uplift Desk FRM583 Replacement Instructions

V2 4-Leg Conference & Ping Pong Table
Foot Replacement Instructions
FRM583
Package Contents
Recommended Assembly Workspace & Practices
• Place all parts on a clean surface such as a rug or carpet to avoid scratches.
• At least four people are recommended for assembly.
• Remove all packaging materials before beginning the assembly process.
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
V2 4-Leg Foot
(qty 2)
M6x14 Machine Screws
(qty 16)
Step 1
A. Remove all objects, accessories, and attached
components from the table since you will be in-
verting it for this installation.
B. Press and hold the Down Button to bring the table
to its lowest position, then unplug the table from
the electrical outlet.
C. Move table to a suitable area free from clutter or
obstruction near a carpet or blanket. Secure any
loose cables before flipping the table.
• Note: Due to the table's size, four people should
flip it to avoid personal injury and table damage.
Place one person on each side of the table, and
raise the table gently in unison.
D. Begin to tilt the table.
• Note: While flipping, hold the frame and the ta-
bletop together whenever possible. Lifting by the
tabletop only could put stress the screws con-
necting the top to the frame, and may cause sep-
aration if the screws are not attached properly.
• The long side with the keypad should be lifted
up and the opposite long side should be low-
ered. The two people holding the short sides
should keep the table stabilized while it's being
tilted.
• As the table is tilted when the person on the key-
pad side is able to get a good grip on both the
tabletop and the frame, the person from the oth-
er long-side should relocate to the keypad side
and grasp the tabletop in the same manner.
• Continue tilting while holding onto the tabletop
and frame together, until the long end rests on
the blanket or carpet.
E. Once the long edge is on the ground, those on
the short side should readjust their grip until they
are holding the tabletop and the frame equally.
Bring the table to a 90 degree position. The two
people from the long side should relocate to the
sides as shown.
4mm Allen Wrench
1