Advertisement

Model: GRJWB05-J6
Please read this manual carefully before operation and keep it well for future reference.
Due to product improvement, Gree reserves the right to change contents of this manual without prior notice.
Gree Electric Appliances, Inc. of Zhuhai reserves the final right to interpret this manual.
WiFi Module Manual
FCC ID:2ADAP-GRJWB05J6
Gree Electric Appliances, Inc. of Zhuhai
IC:12478A-GRJWB05J6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GRJWB05-J6 and is the answer not in the manual?

Questions and answers

Summary of Contents for Gree GRJWB05-J6

  • Page 1 Please read this manual carefully before operation and keep it well for future reference. ● Due to product improvement, Gree reserves the right to change contents of this manual without prior notice. ● Gree Electric Appliances, Inc. of Zhuhai reserves the final right to interpret this manual.
  • Page 2: General Functions

    WiFi Module User Manual 1、General Functions The wireless module complies with IEEE 802.11 a/b/g/n standard and it can achieve up to a speed of 65Mbps with single stream in 802.11n, 54Mbps as specified in IEEE 802.11a/g, or 11Mbps for IEEE 802.11b to connect to the wireless LAN.
  • Page 3: Technique Parameters

    WiFi Module User Manual 2、Technique Parameters Table1. Module Parameters Categories Feature parameters 2.4G: Operating FCC:2412 MHz to 2462 MHz for 802.11 b/g/n(HT40) Bands RED:2412MHz to 2472 MHz for 802.11b/g/n(HT40) 2402MHz to 2480 MHz for BLE 5150MHz to 5825 MHz for 802.11 a/n(HT40) Protocol IEEE 802.11 a/b/g/n frequency...
  • Page 4: Fcc Statement

    WiFi Module User Manual Impedance 50-Ohm Supply electrical +3.3V Voltage specification Connect Internal Antenna physical Dimensions 35.5mm×17.7mm±0.2mm Operating -20-85 deg C. Temperature FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
  • Page 5 WiFi Module User Manual This module has been assessed against the following FCC rule parts: CFR 47 FCC Part 15 C (15.247, DTS and DSS) and CFR 47 FCC Part 15 E (NII). It is applicable to the modular transmitter This radio transmitter 2ADAP-GRJWB05J6 has been approved by Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated.
  • Page 6 WiFi Module User Manual Trace antenna designs: Not applicable. The device must be professionally installed The intended use is generally not for the general public. It is generally for industry/commercial use. The connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter which is not normally required.
  • Page 7 WiFi Module User Manual transmitters, digital circuitry, or due to physical properties of the host product (enclosure). This investigation is especially important when integrating multiple modular transmitters where the certification is based on testing each of them in a stand-alone configuration. 2.10 Any company of the host device which install this modular should perform the test of radiated &...
  • Page 8 WiFi Module User Manual The host product manufacturer is responsible for compliance with any other FCC rules and a C2PC is required for each host when installed in any host. This modular transmitter is only FCC-authorized for the specific rule parts (47CFR Part 15.247) listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
  • Page 9: Canada Statement

    WiFi Module User Manual The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as shown below in addition to any other relevant statements or labeling requirements from e.g FCC Part 15 or the Canadian ICES standards. This device complies with part 15 of the FCC Rules.
  • Page 10 WiFi Module User Manual (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Please notice that if the ISED certification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
  • Page 11 WiFi Module User Manual The host product manufacturer is responsible for compliance with any other ISED rules and a C4PC is required for each host when installed in any host. Le fabricant du produit hôte est responsable de la conformité à toute autre règle d'ISDE et, lorsqu'il est installé...
  • Page 12 WiFi Module User Manual Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter when the module is installed in the host. Must have on the host device a label showing Contains FCC ID:2ADAP-GRJWB05J6 or IC:12478A- GRJWB05J6 Both FCC ID and IC ID are not to be placed on the host at the same time and only hosts going into the US can use the FCC ID and only hosts going into Canada can use the IC ID.
  • Page 13 WiFi Module User Manual...
  • Page 14 Gree Electric Appliances,Inc. of Zhuhai Adresse:West Jinji Rd,Qianshan,Zhuhai,Guangdong,China, 519070...

Table of Contents