UNIVIEW WLN-EB5E-IN Quick Manual

V1.00
LED Colour State
green Power Indicator Light
Network connection light
The light on indicates that the LAN port of the POE
LAN green
power supply is connected to IPC or other network
devices, and flashes when there is data
Wireless indicator light
WLAN green
The light on indicates wireless activation, flashing
when there is data
Signal strength indicator light
red
Only the red light is on, indicating weak or no signal
Only yellow and red lights are on, indicating
yellow
moderate signal strength
All yellow, red, and green lights are on, indicating
green
high signal strength
Equipment installation and commissioning
Adapter
POE
LAN
Schematic diagram of
AP device connection
Quick Guide
Adapter
POE
LAN
Schematic diagram of
CPE device connection
2
Packing List
Please check the product packaging and appearance for obvious damage
first. After unpacking the product, refer to the packing list to check whether
the accessories equipped with the product are available. After confirmation,
the device can be installed and used.
AP Devicex1 CPE Devicex1 Hoopsx4
Device Information
LAN2 POE
Reset
Device
POE port: connected to the POE port with its own power supply
LAN2 port：Reserved network port for connection with front-end
network devices such as IPC
Reset: When the device is working, please press the reset button for
10 seconds and wait for 2~3 minutes to restore the default factory
settings
POE Power
POE port: connected to the POE port of the equipment
LAN port: connect with front-end network equipment such as IPC
Configure and debug:
AP Device
Default IP：192.168.1.35
Username：admin
Password：admin
Device Configuration
No need to modify any configuration, two devices can be automatically
connected and used after being powered on
Trouble shooting for Network failure
1. Please confirm that the devices are installed in pairs, and the serial
numbers of the access point and client devices should be consistent
2. Is the alignment between the devices visible and there are no obstruc-
tions in the middle
3. Whether the indicator light works normally and whether the signal
strength indicator light is normal
Restriction of substances or elements making
Substances or elements which are restricted by Measures for the
Control of Pollution from Electronic Information Products
Part of
the name
Lead Mercury Cadmium
(Pb) (Hg)
x o
Case
x o
Printed Circuit Board
x o
Power Supply(if exists)
x o
Accessory(if exists)
Explanation
o indicates that the content of the restricted substance in all homogeneous
materials of the part is below the limit specified in the SJ/T11363-2006 standard.
x indicates that the content of the restricted substance in at least one of the
homogeneous materials of the part exceeds the limit specified in the
SJ/T11363-2006 standard.
Adapterx2
Power Cablex2 Quick Installation Guidex1
LAN WLAN
CPE Device
Default IP：192.168.1.36
Username：admin
Password：admin
Hexavalent Polybrominated Polybrominated
(Cd) chromium Biphenyl Diphenyl Ethers
(CrVI) (PBB) (PBDE)
o o o
o o o
o o o
o o o
1
o
o
o
o
3