Advertisement
Advertisement
Table of Contents
Summary of Contents for ELECSTOR 3000VA
- Page 1 Offline UPS...
- Page 2 2. If the product has quality problems and is not damaged, disabled or repaired by the user, and is still packaged in good condition, it can be replaced within 7 days of purchase. 3. The Elecstor - Offline UPS Battery comes with the following warranty: 3 month warranty on the battery 6 month warranty on device 4.
-
Page 3: General Notes
Keep your data uncompromised with the Elecstor Offline UPS, designed to keep your workstation on when the power goes out so that you can save your critical data and shut down safely. -
Page 4: Specifications
27. In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach. ⚠WARNING: Do not allow small children to play with the foil. Danger of suffocation! SPECIFICATIONS Model 3000VA Voltage 145-280 ± 5VAC Input Frequency 50hz 50Hz ±1%... -
Page 5: Product Instructions
PRODUCT INSTRUCTIONS Ensure that the voltage, and frequency of the input power is suitable for the UPS. Charge the unit for 8 hours before using the UPS. The UPS will charge only when it is connected. Ensure the UPS has no visible damage. Open the carton and remove the UPS. -
Page 6: Troubleshooting
TROUBLESHOOTING Problems Possible Causes Solutions Make sure the UPS is not overloaded, the ventilation opening is not blocked and the indoor temperature is not too Error code FAL 16 Internal heating high. Wait 10 minutes for the UPS to cool down, then restart. If this fails, please contact our support. -
Page 7: Led Screen
LED SCREEN Display of input and output voltage and frequency Display input power Display UPS output power UPS warning Display battery capacity Display load capacity Battery mode Network mode Silent mode... -
Page 8: Device Settings
DEVICE SETTINGS Parameter 1 Parameter 2 There are two parameters to set. • Parameter 1: Each number refers to a different setting (explanation for all numbers below) • Parameter 2: This parameter is used to change the data of each setting 1: AC Input frequency range Parameter 2: You can adjust the frequency range •... - Page 9 13: Inverter output frequency Parameter 2: Setting the inverter output frequency. • 50: Indicates that the inverter output frequency is set to 50Hz. • 60: Indicates that the inverter output frequency is set to 60Hz The default frequency is 50Hz. 16: Buzzer control switch Parameter 2: Setting for whether the buzzer is enabled.
Need help?
Do you have a question about the 3000VA and is the answer not in the manual?
Questions and answers