Download Print this page

Advertisement

Quick Links

Quick and easy:
en
everything you need to know
about your dishwasher...
You should, however, still
read the installation and
operating instructions before
you use the dishwasher for
the first time.
Pour in the water/special salt
Pour in the rinsing agent
Pour in the cleaning agent
Select the programme
Switch on the appliance
the dishwasher starts...
Press the on/off switch, the cycle time
for the programme selected appears
Switch off the appliance
that's it...
Press the on/off switch when
the indicator shows 0 (programme end)
Inserting the water softening system *
Enter the hardness value ...
Read off the setpoint value ...
ask your
water supplier
* only necessary before the first rinse or
if the water hardness has changed
Dissolves limescale (not required for set value 0!)
Unscrew
the lid.
Cleaning the appliance...
Press the
marking,
Lift the
lid
Little dirt, little cleaning agent
Warning,
combination
products are not
suitable for all
programmes,
follow manufac-
turer's instructions.
Quick, economical or intensive ...
Programme overview
This overview lists the max. possible number of
programmes. The programmes supplied with your
appliance are indicated on the fascia.
The programme data are values measured in the
laboratory in compliance with Standard EN 50242.
Deviations is practice are possible.
Additional programmes **
Soak
Time reduction/
...crockery in the lower
time saving
basket, programme
...shortens the
starts automatically,
cleaning time, reduces
remember to add an
the drying.
extra 5g of cleaning
agent when the door
unlocks.
Quick procedure ...
and enter it as shown below ...
Press and hold
the ECO button
Hold the ECO button until
the required value appears
Press the on/off button
Only before using
Pour in max.
the dishwasher
1.5 kg / 3 lb 5 oz
for the first time
salt (never deter-
pour approx. 1 l /
gent!)
1 1/4 pt water into
the salt opening.
Always refill when the level indicator is clear.
Pour in
the rinsing
agent
Pour in the
cleaning agent
Intesive
Auto
70
55 /65
Duration in minutes
112
95-145
Electricity consumption in kWh
1,60
1,15-1,50
Water consumption in litres
21
11-19
with Aquasensor
18
Increased flexibility ...
Upper basket cleaning
...Only the crockery in the
upper basket is cleaned
** on some models
The ECO indicator lamp
+
and the on/off
and the setpoint value 4
button
flash
The required setpoint
value appears instead
of "4"
The setpoint value
is stored
Screw on the
lid. Switch on
dishwasher
immediately.
Close the
lid.
CLICK
Push the lid
too, press.
PLOP
Pre-rinse
Eco
Gentle
Quick
50
40
45
140
72
30
1,05
0,80
0,80
14
15
10
12
Lower basket cleaning
Time selection
...Only the crockery in the
...switches on as soon as
lower basket is cleaned
you press the time
h.
selection button:
Alters the programme
start in hourly steps
19
0,10
4

Advertisement

loading

Summary of Contents for NEFF GI256161 - annexe 1

  • Page 1 ”4” The setpoint value Press the on/off button * only necessary before the first rinse or is stored if the water hardness has changed Pour in the water/special salt Dissolves limescale (not required for set value 0!) Only before using Pour in max.
  • Page 2 ”0” appears approximately 3 seconds while Switch off the appliance. large remnants of jam, dairy products and food) according to the operating instructions and check that The programme will stop the programme is running the spray arms can rotate freely.

This manual is also suitable for:

S55t57x0eu - annexe 1Gi256161 1