Sunricher SR-2400PD Manual

NFC Programmable 2-Key Push to DALI Control Unit
Important: Read All Instructions Prior to Installation
Function introduction
2 Channels Push Switch Input/Dry Contact Motion Sensor Input
COM (black): common ground for the 2 keys
K1 (white): first key/motion sesnor input
K2 (white): second key/motion sensor input
NFC position: touch the NFC position
with NFC reception area of your smart
phone to write the settings to the device
DALI Output: DA+(red), DA-(red)
Product Data
Input Signal
Power Supply
Output
Output Current
DALI Current Consumption
DT6, DT8 Tc, DT8 XY, DT8 RGBWAF NFC configurable
Controlled DALI Device Type
Operation Mode
Push Switch Function
Motion Sensor Parameters
Operating Temperature
Relative Humidity
Dimensions(LxWxH)
SR-2400PD
2-Key Push to DALI
Control Unit
PRI:
Uin=100-240VAC
E505957
Iin=20mA Max
Freq=50/60Hz
SEC:
Uout=16VDC
Iout=50mA Max
ta=-20℃-+50℃
DALI OUTPUT AC INPUT
DA- DA+ N L
AC 100-240V Power Input
L(black): live input
N (white): neutral input
2 channels push switch/dry contact motion sensor
100-240VAC(active)/DALI bus(passive)
DALI signal
50mA
<4mA
Push Dim or Corridor Dim NFC configurable
NFC configurable
NFC configurable
-20°C-50°C
8% to 80%
45.5x45x20.3mm
Product Features
• NFC programmable 2-key push to DALI control unit
• 2 channels push switch input or dry contact motion sensor input
• PD (Push Dim) mode with push switch input or CD (Corridor Dim) mode with dry contact motion sensor input
• PD mode or CD mode can be set through NFC
• Can work as standalone DALI sensors when connecting with dry contact motion sensors and set as CD mode
• 100-240VAC power supply (active mode) or DALI bus powered (passive mode)
• Built-in 50mA DALI bus power supply to control up to 25 DALI DT6/DT8 control gears
• Up to 100 DALI control gears can be controlled while 4 control units connected to AC mains
• DALI current consumption less than 4mA
• Controlled DALI device type can be freely configured through NFC App
• Supported device types: DT6, Tc, XY coordinates, RGBWAF
• Controlled object of each push switch can be freely configured through NFC App
• Supports broadcast, single address, and group control
• Each push switch supports three different operations: short press, long press, double click
• DALI command triggered by the a push switch operation can be freely configured through NFC App
• Each DALI line can install multiple control units for multi control points
• Waterproof grade: IP20
Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Wiring Diagram
PD Mode Push Switch Wiring (Works with 2-gang switch and 1-gang switch )
Connection with 2-gang switch
L2 L1
E505957
COM2 COM1
DALI OUTPUT
DA-
SR-2400PD
2-Key Push to DALI
Control Unit
PRI:
Uin=100-240VAC
Iin=20mA Max
Freq=50/60Hz
SEC:
Uout=16VDC
Iout=50mA Max
ta=-20℃-+50℃
AC INPUT
DA+ N L