Advertisement
Available languages
Available languages
Quick Links
Eding CNC bv
Europaplein 1
Building 31 Unit 0.02
5684 ZC Best
Netherlands
product@edingcnc.com
Wireless Pendant (mk3)
Content:
•
Wireless Pendant
•
USB dongle
•
Antenna
•
Mounting bracket incl. screws
Requirements:
•
PC running Windows 10
•
EdingCNC software version 4.03 or higher
Manuals:
Setup Video
Youtube/edingcnc101
Technical information:
Power supply
Frequency band
Operating Frequency
Modulation Type
Operating channel width
Max. transmitting power
IP-rating
Range max.
Hereby, Eding CNC b.v declares that the radio equipment type
with Directive 2014/53/EU
The full text of the EU declaration of conformity is available at the following internet address:
https://edingcnc.com/product/wireless-pendant/
Page 1 of 4
Read this document and the manual.
Online Manual
docs.edingcnc.com/hardware
3V (2x AA battery, not included)
433.050 – 434.790MHz (ISM)
433.92MHz
FSK
113.04kHz
10dBm
IP40
25m line-of-sight
and other directives and regulations applicable to the product.
Website
edingcnc.com
Wireless Pendant (mk3)
is in compliance
Revision 1
16-5-2024
Advertisement
Related Manuals for Eding CNC Wireless Pendant mk3
Summary of Contents for Eding CNC Wireless Pendant mk3
- Page 1 10dBm IP-rating IP40 Range max. 25m line-of-sight Hereby, Eding CNC b.v declares that the radio equipment type Wireless Pendant (mk3) is in compliance with Directive 2014/53/EU and other directives and regulations applicable to the product. The full text of the EU declaration of conformity is available at the following internet address: https://edingcnc.com/product/wireless-pendant/...
- Page 2 Eding CNC bv Europaplein 1 Building 31 Unit 0.02 5684 ZC Best Netherlands product@edingcnc.com Operating Notes: WARNING: Only use in dry indoor environments. Before first use install the two AA batteries at the back of product. For opening the battery compartment a small Philips screwdriver is required. Remove rubber outside of product to access battery compartment.
- Page 3 IP40 Reichweite max. 25m Sichtlinie Hiermit erklärt Eding CNC b.v, dass der Funkgerätetyp Wireless Pendant (mk3) der Richtlinie 2014/53/EU und anderen für das Produkt geltenden Richtlinien und Vorschriften entspricht. Der vollständige Text der EU-Konformitätserklärung ist unter folgender Internetadresse verfügbar: https://edingcnc.com/product/wireless-pendant/...
- Page 4 Eding CNC bv Europaplein 1 Building 31 Unit 0.02 5684 ZC Best Netherlands product@edingcnc.com Betriebshinweise: WARNUNG: Nur in trockenen Innenräumen verwenden. Legen Sie vor dem ersten Gebrauch die beiden AA-Batterien auf der Rückseite des Produkts ein. Zum Öffnen des Batteriefachs ist ein kleiner Kreuzschlitzschraubendreher erforderlich.
Need help?
Do you have a question about the Wireless Pendant mk3 and is the answer not in the manual?
Questions and answers