Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for MClimate T-Valve
- Page 1 MClimate T-Valve LoRaWAN® User manual...
- Page 2 Pour savoir comment installer MClimate Para saber cómo instalar MClimate mclimate.eu/lorawan-resources T-Valve LoRaWAN®, escanee el T-Valve LoRaWAN®, scannez le code QR ou visitez le lien à côté de celui-ci. código QR o visite el enlace al lado. Need some help? For more product information and issues related to it, visit: mclimate.eu/lorawan-resources...
- Page 3 Technical details, Safety instructions, Legal Notices & Compatibility Device Parts, Mechanical dimensions Commissioning LEDs and behaviour 9-10 Optional installation of external accessories a. Installing a wired flood sensor b. Installing an external power supply 10 cm 11-14 MClimate T-Valve LoRaWAN®...
- Page 4 Optionally a wired flood sensor and external power supply can be installed. T-Valve instructions in the operating manual. gives you the opportunity to stop...
- Page 5 Device parts OK button Leak LED Flood LED Close button Open button Open LED Close LED Device, top view...
- Page 6 Optional cable-gland Flow direction indication Outlet Inlet Optional cable-gland Device, bottom view...
- Page 7 Commissioning Continue the Installation with the instructions of Before you install the device, we highly recommend your LoRaWAN® Network provider. that you first commission it on your LNS. Once the device is activated it will initiate a LoRaWAN Join Procedure on SF9. Please, make sure you enable ADR in your LNS and/or mark the device as static.
- Page 8 Commissioning Out of the factory, T-Valve comes in deep-sleep mode and it has to be initially activated in order to start normal operation. In deep-sleep mode the device is not transmitting or receiving any data in order to preserve the battery before being installed.
- Page 9 Commissioning If T-Valve is NOT connected to a network, when one presses the OK button, an alternating animation of the Flood, Leak, CLOSE & OPEN LEDs will be shown. Once the device has received Join Accept from the LoRaWAN® Network, it will not show the above-described animation.
- Page 10 T-Valve may indicate that there’s not enough to perform the desired action. Inside, a large capacitor is charged, which takes approx 1s to recharge. If you try to OPEN or CLOSE the T-Valve and this capacitor is not yet fully charged, the OPEN or CLOSE LED will blink 3 times.
- Page 11 OK button Leak LED Flood LED Close button Open button Open LED Close LED...
- Page 12 The power supply DOES NOT charge the battery inside T-Valve. In order to install an accessory, you will need an appropriately IP-rated cable-gland, which can be supplied by MClimate. In order to install a cable-gland, one has to first...
- Page 13 In order to install the cable-gland, one must disassemble the device using the four Phillips screws. If the device is connected to a network, the anti-tamper protection will be activated and the device will signal in the uplink that the device is opened.
- Page 14 flood sensor The wired flood sensor can detect whether a cable is broken or cut. Feed the connector through the cable-gland and install it on T-Valve PCB as described in the picture below. Flood Sensor f- and f+ pins...
- Page 15 Optional installation of external accessories a.Installation of external power supply The external power supply is also fed through a cable-gland and installed on the T-Valve PCB according to the picture below. External power supply Pwr and GND pins from P10 connector.
- Page 16 Designed & Manufactured by MClimate in Europe. last update: 28.05.2024...
Need help?
Do you have a question about the T-Valve and is the answer not in the manual?
Questions and answers