Do you have a question about the DriveTite and is the answer not in the manual?
Questions and answers
Summary of Contents for VIEWRAIL DriveTite
Page 1
Cable Cutters Ensure that your posts and handrail are properly installed before 10mm Crimper beginning your cable installation. DriveTite Wrench For wood + Viewrail Metal Posts Systems: Match the hole spacing Drill on your posts. 3/16 Drill Bit T25 Drive Bit For more information or installation help, go to www.youtube.com/Viewrail...
Page 2
Mark a vertical center line the length of the area where DriveTite will be installed. Cut the cable to the “Needed Cable Length”.
Page 3
Crimp the threaded crimp fitting twice onto each end of the cable. Tension following this sequence.
Page 4
DriveTite Exterior – For Use on All Angle Runs DriveTite Exterior – For Use on All Angle Runs These are the parts for the These are the parts for the Drill pilot holes. Drill pilot holes. 3 1/8" Max Cable Spacing...
Page 5
DO NOT TIGHTEN YET! Tighten cable in this order. Tighten cable in this order. is included in the DriveTite Installation Kit Now tighten both ends to tension cables. Barrel Fitting as Get the screw started, Use pliers to keep the Barrel Fitting shown to hold but don’t tighten.
Page 6
Congratulations! Your Install is Done We’d love to see your work! Snap a few pics with your phone and send them to pictures@Viewrail.com. Thanks for choosing Viewrail. Enjoy your new installation! viewrail.com Version 1.0 — 10-2019...
Need help?
Do you have a question about the DriveTite and is the answer not in the manual?
Questions and answers