Rio ULTRASONIC FACIAL User Manual

user guide
W A R N I N G S
• Please read all instructions
thoroughly and retain for future
reference.
• This product can be used by children
aged 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning the
use of the product in a safe way and
understand the hazards involved.
• Do NOT use on scars, broken skin,
rosacea, pustular or inflamed acne,
abraded skin eczema,
inflamed or diseased skin, or any other
skin ailment. It is recommended that you
consult a doctor if you are unsure.
• For external use only.
YOUR ULTRASONIC FACIAL
Stand
Protective Sleeve
1
Blade Tip
2
Ultrasonic Blade
3
Control Panel
4
High Intensity Light
5
Pulsing wave Light
6
Low Intensity Light
7
DEEP CLEANSE TREATMENT
PROGRAMME SELECTION
damaged,
1
2
3
4
5
6
7
8
9
0
!
@
Programme
8
Select Button
Power Button
9
Battery Indicator Light
0
Charging Socket
!
USB Charging Lead
@
Turn the unit on by pressing the power
button.
Low Intensity Continuous Wave
programme
The Low Intensity Continuous Wave
programme is automatically selected.
We recommend starting treatment on
the Low Intensity Programme.
Press the programme select button
twice to select the High Intensity
Continuous Wave programme.
High Intensity Continuous Wave
programme
When this programme is selected, the
high intensity light will illuminate blue.
YOUR ULTRASONIC FACIAL
CHARGING
When the battery is low, the unit will beep 6 times and
automatically turn off.
Connect the USB charging lead to the
charging socket and plug into the USB
power source.
When the unit is charging, the battery
indicator light will illuminate red.
When the unit is fully charged, the
battery indicator light will go out and
your product is ready to use.
After charging is complete disconnect
the USB charging lead from the unit
and unplug from the power source.
NOTE: This may take up to 8 hours
START TREATMENT
Apply warm water to your face.
1
Note: For best results use after bathing
or showering. We recommend 1 to 2
treatments a week.
Turn unit on by pressing the power
2
button. Select the Low or High Intensity
Pulsing Wave programme.
Saturate a piece of cotton wool and
3
hold the unit so that the control panel
is away from your face.
Move the wet cotton wool ahead of
4
the blade and in the same direction,
keeping the skin taught and maintaining
light to medium contact with the skin.
You will see a fine spray of water, dirt
and grime coming off the front edge of
the blade.
After use, turn the unit off by pressing the power button.
The blade may be cleaned by wiping with a damp cloth.
Store with protective sleeve on the blade.
Note: If left on, the unit will automatically turn off after
10 minutes.