Summary of Contents for Crompton GrandArt CHD-GAVB90FLE-MBL
- Page 1 INSTRUCTION MANUAL Installation, Operation and Maintenance of Cooker Hoods CHD-GAVB90FLE-MBL GrandArt CHD-GAVI90FLE-MBL CHD-GAL90BFE-INX...
-
Page 2: Table Of Contents
Warning & Safety Instructions Precautions Installation Product overview Usage a. Control panel overview b. Features Cleaning and Maintenance Trouble Shooting Guide Specifications & Technical parameters 17 Warranty After Sale Service Warranty Registration Card... -
Page 3: Warning & Safety Instructions
Simply scan the QR code here to register your product WARNING & SAFETY INSTRUCTIONS Please use the appliance strictly complying with the user manual. Crompton will not bear responsibility for property loss and personal injury due to improper use. WARNING: If you ignore the following instructions and operate the appliance incorrectly, you may put people in danger, cause serious injuries, or start a fire. - Page 4 While drilling on the roof or ceiling, please make sure not to damage the electrical wires or any other hidden devices This appliance is only for domestic use. Do not use it in special environment (eg Outdoor), and it should not be used to exhaust dangerous or explosive substance or gas.
-
Page 5: Precautions
PRECAUTIONS: Ensure that the main voltage corresponds with the recommended voltage of the ® Cooker Hood - 230V AC, 50Hz. Connect the Cooker Hood to the electric supply with proper earthing. ® When installed, the minimum gap between the Cooker Hood and the cooking ®... - Page 6 IMPORTANT NOTE Please read the operating manual carefully before installation / use. ® The installation work must be undertaken by Crompton authorized service ® personnel only. Please ensure that the main voltage corresponds to the one mentioned on the rating label of the appliance Ensure that the installation is carried out as per enclosed Installation guidelines ®...
- Page 7 PRE – INSTALLATION INSTRUCTIONS 1. Install the Cooker Hood in a dry place without any direct sunlight. 2. The following tools would be required for the installation Pencil Level Tube Drill Machine Drill Bit Screw Driver Measuring Tape 3. Before installing the Cooker Hood remove any protective film if present on the Cooker Hood unit and the filters 4.
- Page 8 INSTALLATION STEPS Ducting Mode (recommended for all models) Point 1 will be marked at a height A from the hob/gas stove. Point 2 is marked by measuring the height B from the bottom part of the main Cooker Hood unit. Please refer to the below image to determine the heights A and B for your Cooker Hood model.
- Page 9 Step 5: Now with the help of two or more people, lift the main Cooker Hood unit and hang it on the Cooker Hood wall mounting bracket. Once the Cooker Hood unit is fixed to the bracket, try moving the unit a little to ensure that it is firmly fixed. Remove the hand support only when you are fully assured that it is firmly fixed otherwise there is a risk that the Cooker Hood unit may fall and break.
-
Page 10: Product Overview
PRODUCT OVERVIEW CHD-GAL90BFE-INX CHD-GAVB90FLE-MBL CHD-GAVI90FLE-MBL USAGE CONTROL PANEL OVERVIEW Firstly, let's become familiar with the Cooker Hood control interface. For CHD-GAVB90FLE-MBL & CHD-GAVI90FLE-MBL models Display/Timer Auto Clean Booster Light Power Speed Auto Clean Booster speed Slider for speed Power Long press 3 sec Super high speed Light control... -
Page 11: Features
For CHD-GAL90BFE-INX model Power/Display /Timer Auto Speed Speed Delay Light Clean Decrease Increase FEATURES For CHD-GAVB90FLE-MBL & CHD-GAVI90FLE-MBL models POWER After power on, all the key backlight and display screen self-check and light up once, and sound a beep with the buzzer. One second later, the backlight off, the display screen displays 12:00, and enters the shutdown state. - Page 12 GESTURE CONTROL Gesture control is ability to recognize and interpret movements of human body to interact with and control a PCB system without direct physical contact. This will avoid poor touch caused by oil/grease on hand. Put your hand up in front of the sensor area, reasonable distance is 50mm, then start to control cooker hood by hand gesture: from left(right) to right(left).
- Page 13 SLIDER / SPEED CONTROL In the standby state, slide the bar along the display screen to adjust the speed level conveniently. From right to left slide can be used for 8 to 1 of decreasing level, while from left to right slide can be used for 1 to 8 of increasing level. The digital screen should display the current speed level CLEANING OF OIL COLLECTOR TRAY 1) This cooker hood has been provided with a unique high quality metal oil...
-
Page 14: Cleaning And Maintenance
4) Install the clean filter back on to the cooker hood with the help of two screws. Make sure that the filter is dry before installing. In view of Crompton policy of continuous development and improvements, specification and features are subject to change without prior notice. -
Page 15: Trouble Shooting Guide
Call the customer service center After cleaning the Cooker Hood, Make sure the installation is tight. failure to install balanced or Only Crompton authorized service tightened parts such as motor personnel should clean of the housing and impeller. motor housing and impeller. - Page 16 The distance of Cooker Hood and Call Customer Service Center for stove top are too high. technician visit to check if hood needs to be reinstalled. The exhaust pipe is loosely Call Customer Service Center for installed or bent in many places, technician visit to check if resulting in bad exhaust exhaust pipe needs to be...
-
Page 17: Specifications & Technical Parameters
Values mentioned in above table are as per testing under standard lab conditions. Values may vary as per product usage. In view of Crompton policy of continuous development and improvements, specification and features are subject to change without prior notice. - Page 18 ® Free of Cost (depending upon model number or if promotional scheme is announced by Crompton from time to time) for the first buyer only. For repeat installation requests and models not offered with Free installation and/or ducting kit, installation and/or ducting kit charges will have to be borne by the customer.
- Page 19 This warranty shall not cover any consequential or resulting liability, damage or loss ® to property or life arising directly or indirectly out of any defect in the Crompton Products. The company's obligation under this warranty shall be limited to repair or providing replacement of defective parts/product only under the warranty period.
-
Page 20: After Sale Service
This symbol is known as the Crossed-out Wheelie Bin Symbol. This means that product should not be disposed of with your general house-hold waste. We as Crompton, always here to assist you Simply scan Please call Crompton service on 1800 419 0505 (Toll Free),... -
Page 21: Warranty Registration Card
WARRANTY REGISTRATION FORM For Installation Service / Complaint Kindly call us on 1800 419 0505 (All India toll free number) It is mandatory to install the Cooker Hood. by calling our toll-free no. and by our authorised service center only Dealer Name &... - Page 22 WARRANTY REGISTRATION FORM Name of Customer: Mr/Ms: Address : City : Pin Code: State: Phone No. (Resd./Office): Mobile Number: Email :...
Need help?
Do you have a question about the GrandArt CHD-GAVB90FLE-MBL and is the answer not in the manual?
Questions and answers