Using CartManager Ultra – Remote Operation Mode (Using Remote Control)
Never walk directly in front of a line of moving carts or stand in front of the
CartManager Ultra cart pusher when the unit is moving!
Press the Red OFF button at any time to disconnect the remote's command
to the CartManager Ultra unit. This will bring the CartManager Ultra unit to
a rolling stop.
In remote operations mode, a handheld Remote control unit is used to control the CartManager Ultra, instead of the Throttle Knobs. The oper-
ator steers the line of carts from the side of the front cart.
Once the Pre-Checklist has been performed:
1. Place the rear wheels of a cart into the Cart Cradles, as shown right.
2. Switch the Power Switch ON and the Battery Level Indicator will display one bar scrolling
across the Display.
3. With the Remote control in hand, move to the side of the front of the cart, facing forward.
4. Pressing and release the Green button. The red power indicator on the Remote will light
while the button is pressed.
5. Press and release the Horn button once or twice to alert persons that you are in the area.
If the horn does not sound, refer to Troubleshooting .
6. With one hand on the front corner of the cart, press and hold the turtle (slow) button.
The CartManager Ultra will begin to move slowly forward.
7. While holding the Slow Button down, push or pull the front of the cart and the cart and
CartManager Ultra will turn in that direction.
8. Release the Slow Button and CartManager Ultra will stop.
9. Now press and hold the Rabbit (fast) button. CartManager Ultra will move forward, but
much faster.
NOTE: To conserve the Remote battery, if unit is inactive for more than a minute, CartManager will go to sleep mode, press Green button on
remote to enable driving.
Power Indicator
Red LED
Off Button
Rabbit Button
Fast
Horn
Green Button
Turtle Button
Slow
Display Button
Shows Error Codes
8
CartManager User Manual
Need help?
Do you have a question about the CartManager Ultra and is the answer not in the manual?