Related Manuals for Qettle SIGNATURE MODERN
Summary of Contents for Qettle SIGNATURE MODERN
- Page 1 Signature QETTLE 4-IN-1 SIGNATURE MODERN BOILING & FILTERED WATER TAP INSTALLATION & USER GUIDE...
- Page 2 2) QETTLE Boiler This guide explains how to install a new QETTLE Signature boiling 3) QETTLE water filter complete with a Q08 filter cartridge water appliance.
-
Page 3: Before You Begin
Heating Up Time - 2L Boiler Mins is advisable to check the circuit to establish whether 4L Boiler Mins or not the addition of a QETTLE tap will overload the 7L Boiler Mins circuit. Important Note: The boiler should not be fitted Recovery Time -... -
Page 4: Components List
10. NutRunna® hand-tightening device for G1/4” nuts x2 11. NutRunna® hand-tightening device for G1/2” nuts x4 12. QETTLE boiler 12a. QETTLE 2 Litre Boiler 12b. QETTLE 4 Litre Boiler 12c. QETTLE 7 Litre Boiler 13. Push-fit elbow (attached to Boiler power cable) 14. -
Page 5: The Installation Procedure
THE INSTALLATION PROCEDURE INSTALLING THE QETTLE 4-IN-1 KITCHEN TAP Carrying out this operation first will make it easier to plan the layout inside the cabinet. For safety it is advisable to locate the tap out of the reach of smaller children. Important note: The tap fixing studs are factory fitted and should not be tightened or loosened. - Page 6 THE PLUMBING INSTALL THE FILTER UNIT Important Note: Before installing the new tap it is essential that Important Note: The filter unit must be installed inside a cupboard. you thoroughly flush through the supply pipes in order to remove Long term exposure to direct light can degrade the plastic sump any remaining swarf, solder or other impurities.
- Page 7 U Bend, waste trap, side/underside of the waste pipe. Option 2 • If the QETTLE system is being installed on a sink with a waste disposal unit, the vent assembly must be installed on a sepa- rate waste pipe to the waste disposal unit.
- Page 8 INSTALL THE BOILER INSTALL THE FILTER CHANGE INDICATOR MODULE Important note: Do not plug the boiler into the power supply at 1. Choose a convenient location for the module, making sure that this stage. the attached power cable is within easy reach of the mating cable attached to the base of the tap.
-
Page 9: Commissioning The System
2. Turn on the water supply. Warning Strip 3. Operate the boiling water function for 3 minutes to flush the system. (Please see the OPERATING THE QETTLE TAP overleaf). 4. Turn the tap off and check the connections for leaks. -
Page 10: Care And Maintenance
CLEANING THE QETTLE TAP The body of the tap is clearly marked to show the 4 functions. The QETTLE Signature tap is manufactured in stainless steel and is NORMAL UNFILTERED MAINS HOT AND COLD WATER. therefore extremely durable and stain resistant. All that is required... -
Page 11: Changing The Filter Cartridge
15. Repeat steps 13 & 14 flush through the filtered & boiling sides 8. Turn the water supply ‘on’ and check the system carefully for of your QETTLE again. leaks. 16. Now follow the CHANGING THE FILTER CARTRIDGE steps adja- 9. - Page 12 THE BOILING WATER FLOW IS AGITATED AND NOISY WATER IS CONTINUALLY DRIPPING/RUNNING INTO THE VENT ASSEMBLY. Please bear in mind that your QETTLE 4-in-1 Tap system is dispensing boiling water, rather than very hot water, and as a Water continuously discharging from the vent indicates that the consequence there will be the normal steam, agitation and noise water pressure is too high;...
- Page 13 CONDENSATION IS DRIPPING FROM EXPOSED COPPER PIPES ADJACENT TO THE BOILER. If you are still experiencing problems after completing these steps please contact QETTLE on 01603 875 464. This can be reduced by wrapping insulation around the pipes in question.
- Page 14 • Faulty installation, repairs or alterations not in accordance with the installation guide. QETTLE Boiler - 2 Years QETTLE water filter complete with a Q08 filter cartridge - 2 Years • Normal wear and tear. • Accidental damage or faults caused by negligent use or care;...
-
Page 15: Declaration Of Conformity
The QETTLE 4-in-1 system is a product designed by Greg Rowe Ltd. England and is protected by the following patents: US9,958,075, GB1515293.7 and the following patent applications: 1517097.0,... - Page 16 QETTLE Old Winery Business Park Chapel Street Cawston, Norfolk NR10 4FE Phone: +44 (0)1603 875 464 Email: support@qettle.com Part No: 999705 QETTLE is a trading name of Greg Rowe Limited...
Need help?
Do you have a question about the SIGNATURE MODERN and is the answer not in the manual?
Questions and answers