Omron FB LIBRARY Startup Manual page 68

2-6. Inverter setting
For performing DeviceNet Communication, the following parameters have to be set.
* The parameters shown here is incorporated into DeviceNet communication Unit when power is
turned ON.
For this reason, change of parameter must be made after turning OFF the source power.
2-6-1. 3G3M series Inverter Parameter Setting
Parameter
constant No.
Operation command
n003
selection
Frequency command
n004
selection
Unit selection at
n035 frequency command
selection/reference
Concerning other parameters set depending upon operation conditions.
Concerning change and detail of parameter, check the following manuals.
2-6-2. 3G3RV series Inverter Parameter Setting
Parameter
constant No.
Frequency command
b1-01
setting
Operation command
b1-02
selection
Operation selection at
F6-01
communication error
Detection method selection
F6-02 at communication outer
error input
Operation selection at
F6-03
communication outer error
input
Unit selection at frequency
o1-03 command
selection/reference
Concerning other parameters set depending upon operation conditions.
Concerning change and detail of parameter, check the following manuals.
I532-E1 3-2 Digital Operator
I539-E1 4-2 SYSDRIVE 3G3RV Series Set-up
Setup
Name
figure
3
9
0
I527-E1 3-1 Operation of Digital Operator
I539-E1 4-1 SYSDRIVE 3G3MV Series Set-up
Setup
Name
figure
2-6 Inverter
Factory
setting
Input from option (DeviceNet
0
Communication Unit) is enabled
Frequency command from option
0
(DeviceNet Communication Unit) is enabled
0 Unit: Hz
Factory
setting
Frequency command by Option Card
3 1
(DeviceNet communication card)
Operation command by Option Card
3 1
(DeviceNet communication card)
1 1 Free run stop/error detection
0 0 Detect always
1 1 Free run stop/error detection
0 0 Unit: Hz
3G3MV-A2 /-AB
3G3RV-A2 /-A4
Description
Description
/-A4