Tattletale Borderguard Instruction Manual

Borderguard
(continued)
Follow these steps to change the battery:
1.
Use screw driver to turn the blue slot (located on the bottom
of sensor) counter clockwise to release the front cover.
2.
Depress the 2 tabs located on the top inside of the sensor
to release the sensor from its case. The transimitter is
located on the backside of the sensor module.
3.
Locate and replace the CR123A battery, being careful to
align the positive (+) and negative (-) ends as indicated by
the markings inside the battery housing.
4. Press the black RESET button on the transmitter opposite
the battery (Fig.1).
5.
Test the sensor. (For directions on testing the sensor, see
reverse page)
Fig. 1
( transmitter with case open)
3V CR 123A battery
tattletale portable alarm systems, inc. | tattletale.com 1.888.TELL.ON.U | 6269 Frost Road Westerville, OH 43082
Be sure to press
the reset button after
changing the battery
Borderguard
G E N E R A L I N F O R M A T I O N
The Borderguard Dual Beam Motion Detector can be placed up to 2000
ft from the tattletale™ base unit. The Borderguard is designed to protect
the exterior of a building, property, or fence. It is sensitive to moving heat
and has an adjustable coverage area. The detector utilizes dual beams to
project up to 40 ft from each side of the sensor (Fig. 2, see reverse page).
It can operate normally between -4°F and 122°F, is weather resistant, and
IP55 rated. The 3V CR123A Lithium battery provided will typically last for
2-3 years depending on usage and environment.
Mounting instructions:
1.
Use screw driver to unlock front cover, remove front cover,
depress tabs to remove the center section the back housing.
Rear view
Mounting screws back housing
Built-in level Tamper Switch
2.
Screw back casing of the unit to a permanent post or exterior of the building. Make sure the
sensor is mounted securely with tamper switch fully depressed. Use integrated level to assure
proper leveling of sensor. Failure to do so could result in undesired operation.
3.
Mount the Borderguard at a height of 31" to 48"(ideally 48".) (The sensor is looking for knees and
shoulders of an intruder.)
Reattach center section to the back housing by inserting the bottom taps into the housing first
5.
and then rotating the part forward until the tabs lock in place.
Reattach the front cover by first inserting the top of the cover into the back housing, then rotating
6.
the front cover downwards and pushing firmly to lock it in place.
Back
housing
Center
section
Cover
Lock located on
bottom of back housing