SAFETY & WARNINGS • This leg massager is intended for the temporary relief of minor muscle aches and pains and for the temporary increase in circulation to the treated leg in people who are in good health. The leg massager simulates kneading and stroking of tissues by using air- inflatable boots.
Page 4
Safety Precautions • Do not use a voltage higher than the leg massager requires. • Do not allow a third party to repair or dismantle the leg massager. • Do not dismantle the leg massager yourself. • Do not use the leg massager in a place where it may become wet or damp. Do not use the leg massager if it becomes wet.
OVERVIEW Air Compression Boots (Left/Right) Remote Control Display Screen Control Panel Velcro Strap Air Pressure Hose Ports Air Pressure Hoses (Left/Right) Adapter...
OPERATION • This leg massager consists of an air pump, two solenoid valves and air compression boots working together as one leg massager. • The air pump is connected to the air compression boots with air hoses. • Each boot has 3 compression chambers that inflate and deflate. •...
Page 7
Connect the Air Hoses to the Control Panel Insert the air pressure hoses into the corresponding ports on the control panel. Note: Ensure is facing up and the R is facing down. Air pressure cannot be produced if the leg massager is not configured correctly.
Page 8
Wearing the Leg Massager Place your foot into the massager. Secure the Velcro strap on the foot first, then follow the sequence below to secure the other Velcro straps. Note: Secure both Velcro straps on the calf. Calf Instep Calf Foot Thigh Knee...
Page 9
Using the Leg Massager • Press the power button for 2 seconds to power the leg Power massager on/off. • When first powered on, the leg massager will have the following default settings: Auto mode, mid intensity, high heat, and level 3 vibration. Mode Press the mode button to switch between Auto, Leg, Foot, Pinch, Press and Relax modes.
Page 10
Modes Auto: Calf and feet pressure massage. Leg: Only calf pressure massage. Foot: Only foot pressure massage.
Page 11
Pinch: Calf and feet pressure massage. Press: Calf and feet pressure massage. Relax: Calf and feet pressure massage. Note: • Sit or lie down when using the leg massager to avoid falling. • The leg massager will remember the previous settings and return to them by default when powered on.
CLEANING & CARE Cleaning • Before cleaning, power off the leg massager and unplug the hoses. • Wipe the leg massager with a cloth dampened with neutral detergent and warm water. Always wring out the cloth before cleaning. • Never use thinner, benzine or alcohol to clean as they may cause discolouration or malfunction.
Page 13
Storing the Leg Massager Secure the Velcro on the feet (1), ankles (2) and calves (3) and fold the feet Velcro inwards (4). Fold the folded feet, ankles, and calves upward and place the hoses on top (5). Secure with the knee and thigh Velcro straps (6, 7). Maintenance •...
SPECIFICATIONS Power Specifications DC 12V/2A Power 24 W AC Adapter 100-240VAC, 50/60Hz 0.8A Pressurisation Automatic pressurisation Therapy Time (Automatic Shut-off) 20 mins Recommended Use Twice a day (i.e. 40 minutes per day) Weak: 23±2kpa Foot Medium: 27±2kpa Strong: 31± 2kpa Weak: 23±2kpa Massage Intensity Calf...
Under what circumstances should I not the leg massager? Answer: Always check the Safety & Warnings section before use. Consult a doctor before using the leg massager if you have any pre-existing health conditions. Do not use the leg massager if you are pregnant, have recently given birth, have a fever or a blood pressure disorder.
TROUBLESHOOTING If the solutions below are unsuccessful, contact help.Kogan.com for support. Problem Solution The leg massager will not Ensure the AC adapter is connected. power on. • The AC adapter is not connected. • The hose connector is loose or broken. Contact The leg massager stops working halfway through use.
Need help?
Do you have a question about the BVAIRPFLEBA and is the answer not in the manual?
Questions and answers