HSS Hire 52121 Operating & Safety Manual

Model 1
Trigger
ON/OFF
Screw Depth
Trigger
Adjusting Knob
Stopper
Plate
Screw
Guide
Screw Strip
Model 2
Extension
Handle
Remote
Control
Trigger
Grip
Handle
Trigger
Cable
Length
Adjustment
Screw
Extension
Handle Bracket
Second
Stopper Plate
Slide
Plate
OPERATE the tool without screws – it will damage
the workpiece.
Once the screw has been driven fully home, lift the
Forward/Reverse tool' s nose clear of the work to advance the screw
Switch
strip ready for the next fixing.
Note, in most cases, there is no need to drill pilot
Lock
holes and countersinks for the screws. This may,
however, be advisable when screwing into hardwoods
or into materials susceptible to cracking.
To change the direction of rotation, press the
forward/reverse switch. FWD for right hand
rotation and REV for left hand rotation. DO NOT
change direction until the motor has completely
stopped.
The long handled version can be used for driving
screws into floors and ceilings while standing.
Belt Clip
Never push the tool beyond its design limits. If it
will not do what you want with reasonable ease, assume
you have the wrong tool for the job.
Keep the equipment clean. You will find this less of a
chore if you clean up regularly rather than wait until the
end of the hire period.
Handle the equipment with care. Avoid dropping it,
knocking it, or otherwise exposing it to damage.
Don't force the tool – It will do the job better and safer
at the rate for which it was designed.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
Before returning the autofeed screwdriver to your
local HSS Hire Shop, remove the screw strip from
the screw guide and wipe over with a clean
damp cloth.
Power
Cable
©HSS Hire Service Group Plc 1997 No. 553/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
EQUIPMENT CARE
FINISHING OFF
Contact your local
0990 282828
Operating & Safety Guide 553
Hire Shops
Autofeed
Screwdriver
For fast, accurate, repetitive
screwdriving. There are two versions,
the standard version will screw up to
41mm. The long handled version will
screw up to 57mm and is ideal for
screwdriving into floors and ceilings.
Code 52121/52122