Anda Seat STEALTH PRO DUO A8-2T Quick Start Manual

A8-2T
06
R
R
If the Upper Arm with monitor falls down and fails to stay where intended.
Turn the inside screw counterclockwise("+"direction) to increase gas spring tension until the arm can stay as intended.
If the Upper Arm with monitor rises up and fails to stay where intended.
Turn the inside screw clockwise("-"direction) to decrease gas spring tension until the arm can stay as intended.
07
For upper arm: Remove the two screws on the Upper Arm using a Alley Key (R). Install the
cable cover (H) and tighten the screws back.
For lower arm: Remove bottom plastic cover from lower arm as shown in the diagram.
32
1.5-12KG
（3.3~26.5lbs)
Loosen the tilting bolt with Allen Key (R). Hold
the bottom of monitor with one hand and
adjust to determine your desired tilt angle.
Retighten the tilting bolt towards "＋" to fix the
angle.
1
2
H
R
R
STEALTH PRO DUO A8-2T
DUAL MONITOR ARM
08
For upper arm: Open a gap in the cable cover and run cables through the cable cover;
For lower arm: Run cables through the cable cover, then insert and slide the cover
down for reattachment.
09
±135°
Q
R
1
2
±90°
+35°
±180°
-35°
±180°
Allen Key (Q, R) can be stored in Base Support Cover (G) for
next time using.