HOMCOM 820-282V80 Manual page 3

Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
Do not run power cord under carpeting. Do not cover cord with throw rugs, runners
or similar coverings. Arrange cord away from traffic area where it will not be tripped
over.
To disconnect heater, turn controls off then remove plug from outlet.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline,
paint or flammable liquids are used or stored.
Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock or injury to persons or property.
USAGE
HEATER OPERATION: Always operate the heater in the upright position following
all instructions and recommendations listed in this manual HEATER LOCATION:
Place the heater in the area of the room that is coldest. HEATER CONNECTION:
Plug heater directly
Into 120 volt A.C., 60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or heater. NOTE: To
prevent overloading a circuit, do not plug the heater into a circuit that is servicing
other electrical needs.
TURNING HEATER ON:
For Flame Effect Only- Slide main power ON/OFF switch to ON position to have the
flame effect without any heater functions.
For Low Heat-Slide main power ON/OFF switch to ON position and Slide switch "I"
to ON position.
For High Heat-Slide main power ON/OFF switch to ON position and slide both
switch "I" and switch "II" to ON position.
Adjustable Thermostat
ON/OFF Switch:
Main Power &
Simulated Flame (without heat)
Two Switches for HEAT SETTINGS:
●Switch l = Low
●Switch l + ll Combined = High
2