Related Manuals for Aerpro AP477H
Summary of Contents for Aerpro AP477H
- Page 1 5W UHF CB RADIO ULTRA COMPACT HIDEAWAY MULTICOLOUR MULTICOLOUR DISPLAY DISPLAY USER GUIDE aerpro.com 20-05-24...
-
Page 2: Table Of Contents
CONTENTS WELCOME ..................PAGE: 4 FEATURES ..................PAGE: 4 BOX CONTENTS ................PAGE: 4 TECHNICAL SPECIFICATIONS ..........PAGE: 4 SAFETY INFORMATION AND WARNINGS ......PAGE: 5 RADIO CONTROLS ..............PAGE: 7 LCD DISPLAY ................. PAGE: 8 RADIO OPERATIONS - Power ON/OFF ............. PAGE: 9 - Squelch level .............. - Page 3 CONTENTS (continued) MENU SETTINGS - COL-Screen colour............PAGE:12 - LIT-Screen brightness ..........PAGE:12 DUPLEX/REPEATER INFORMATION ........PAGE:13 UHF CB CHANNEL GUIDELINES ..........PAGE:14 UHF CB CHANNELS AND FREQUENCIES - UHF channel frequency table ........PAGE:15 - CTCSS tone table ............PAGE:16 - DCS code table ............
-
Page 4: Welcome
INTRODUCTION WELCOME Thank you for purchasing the Aerpro AP477H 5 Watt UHF CB Radio. Please ensure that you have read the product manual and instructions in full, prior to installation and use. Failure to do so may result in product failure/damage or incorrect operation and therefore impact the product performance. -
Page 5: Safety Information And Warnings
SAFETY INFORMATION AND WARNINGS INFORMATION ON SAFE OPERATION Please read this information before installing or using your UHF radio. The operation of your UHF radio in Australia is subject to conditions in the following Licence: In Australia the ACMA Radio communications (Citizen Band Radio Stations) and in New Zealand by RSM the General User Radio Licence for Citizen Band Radio. - Page 6 SAFETY INFORMATION AND WARNINGS (continued) ELECTROMAGNETIC INTERFERENCE/COMPATIBILITY Nearly every electronic device is susceptible to electromagnetic interference (EMI). To avoid the possibility of electromagnetic interference and/or compatibility conflicts, turn off the radio in any location where posted notices instruct you to do so such as health care facilities.
-
Page 7: Radio Controls
RADIO CONTROLS RADIO LAYOUT Power ON/OFF Channel Channel FIG. 1 DOWN Display Screen Push To Talk Button Scan Button Memory/Function Instant Recall Volume Down Volume Up RJ45 microphone input... -
Page 8: Lcd Display
LCD DISPLAY LCD DISPLAY Instant channel Channel Number 01-80 Duplex Mode Scan Roger Beep Button Beep CTCSS/DCS Code Transmit & Receive Signal Meter CAUTION When installing your radio in your vehicle, check that during installation you do not damage any wiring or vehicle components that may be hidden around the mounting position. -
Page 9: Radio Operations
RADIO OPERATIONS POWER ON/OFF To turn the AP477H ON, press and hold the power button on the top of the transceiver. The LCD display will light up, indicating the unit is now ON. To turn the AP477H OFF, press and hold the power button on the top of the transceiver. -
Page 10: S Button-Scanning
RADIO OPERATION S BUTTON - SCANNING SCAN mode (If enabled in menu settings). Press the (S) button and the radio will scan through all 80 channels until it hears a transmission (Busy Channel). The radio will stop on the busy channel until 5 seconds AFTER Transmissions stop – the radio will then commence scanning again. -
Page 11: Menu Settings
MENU SETTINGS SHORT press on the (F) button once. This allows you to enter the menu and change settings as per your requirements. Pressing the (F) button again will step you through the Menu options Some settings are (GLOBAL SETTINGS) affecting ALL Channels when changed Some settings are (PER CHANNEL SETTINGS) affecting only the channel they are set on. -
Page 12: Bcl-Busy Channel Lockout
MENU SETTINGS BCL - BUSY CHANNEL LOCKOUT PER CHANNEL SETTING SHORT press (F) button 4 times This function disables transmission while there is traffic on a channel. You cannot send a transmission. ie your PTT is disabled until there is no traffic on your current channel. - Page 13 MENU SETTINGS RNR - RECEIVER NOISE REDUCTION GLOBAL SETTING SHORT press (F) button 10 times RNR – Receiver Noise Reduction works in conjunction with the next option TNR – Transmitter Noise Reduction ENABLING RNR – Receiver Noise Reduction reduces background noise on your receiver.
- Page 14 DUPLEX / REPEATER INFORMATION DUPLEX RECEIVE / TRANSMIT CHANNEL GUIDE The following table displays the receive and transmit channels when using repeater stations: *Channel 5/35 is emergency channel only VISUAL REPRESENTATION OF DUPLEX REPEATER CHANNEL 2 / 32 OBSTRUCTION (HILL / MOUNTAIN) VEHICLE 1 VEHICLE 2 RADIO IN DUPLEX MODE ON CHANNEL 2...
- Page 15 UHF CB CHANNEL GUIDELINES RADIO COMMUNICATIONS (CITIZEN BAND RADIO STATIONS) CLASS Licence 2002 NOTE: The operation of your UHF radio in Australia and New Zealand is subject to conditions in the following Licences: In Australia, the ACMA Radio Communications (Citizen Band Radio Stations) and in New Zealand by RSM the General User Radio Licence for Citizen Band Radio.
- Page 16 UHF CB CHANNELS AND FREQUENCIES UHF CHANNEL FREQUENCY TABLE Reserved Reserved Data Only Reserved Data Only...
- Page 17 UHF CB CHANNELS AND FREQUENCIES (continued) CTCSS TONE TABLE (Codes 01 -> 38)
- Page 18 UHF CB CHANNELS AND FREQUENCIES (continued) UHF CB CHANNELS AND FREQUENCIES (continued) DCS CODE TABLE...
- Page 19 UHF CB CHANNELS AND FREQUENCIES (continued) UHF CB CHANNELS AND FREQUENCIES (continued) DCS CODE TABLE (continued)
- Page 20 TECHNICAL ASSISTANCE If you need assistance setting up or using your AERPRO product now or in the future, call Aerpro Support. Australia. TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST service@tdj.com.au Please retain this user guide for future reference.
Need help?
Do you have a question about the AP477H and is the answer not in the manual?
Questions and answers