NOTE: 2019 CXA mono amplifi ers are 1Ω stable - power rating +/- 10%. Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use genuine KICKER accessories and wiring.
A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown (make sure you set the CX amplifi...
MONO OPERATION minimum impedance of 1 ohm woofer ≤18” (45cm) ≤24” external fuse (60cm) battery remote turn-on (see page 5) bare-metal chassis ground bare-metal chassis ground For multiple amplifi er installations where distribution blocks are used, each amplifi er should have its proper-rated fuse, or breaker, installed between the amplifi...
Input Level: The RCA inputs on KICKER CX amplifi ers are capable of receiving either Hi or Low-level signals from your source unit. If the only output available from your source unit is a Hi-Level signal, simply press in the Input Level switch on the amplifi...
There are Power (PWR) & Protection (PRT) LEDs on the side panel of your Kicker CX series amplifi er. Depending on the state of the amplifi er and the vehicle’s charging system, the LEDs will glow either green or red. When the green LED is lit, this indicates the amplifi...
Page 7
The new extended warranty applies only to KICKER amplifi ers and accessories sold to consumers by Authorized KICKER Dealers in the United States of America or its possessions. It also only applies to the original purchaser of KICKER amplifi ers and accessories. One warranty extension per amplifi er is allowed regardless of the number of amplifi er installation kits purchased.
Need help?
Do you have a question about the CX.1 Series and is the answer not in the manual?
Questions and answers