Download Print this page
RocwooD RWAC20V1 Instruction Manual

RocwooD RWAC20V1 Instruction Manual

Cordless ash vacuum cleaner

Advertisement

Quick Links

CORDLESS ASH
VACUUM CLEANER
RocwooD
INSTRUCTION MANUAL
RWAC20V1
WWW.ROCWOOD.CO.UK

Advertisement

loading
Need help?

Need help?

Do you have a question about the RWAC20V1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for RocwooD RWAC20V1

  • Page 1 CORDLESS ASH VACUUM CLEANER RocwooD INSTRUCTION MANUAL RWAC20V1 WWW.ROCWOOD.CO.UK...
  • Page 2 When using the appliance, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions with due care. Keep this manual in a safe place, so that the information is always available. If you give the appliance to any other person, hand over these operating instructions as well.
  • Page 3  Important! The ash vacuum cleaner is not suitable for vacuuming soot or fine dust.  Important! The extracted material must not exceed a temperature of 40°C.  Important! If the temperature of the extracted material exceeds 40°C, there is a risk of fire.
  • Page 4  Make sure the cable is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress.  An extension cable should not be used unless absolutely necessary. Use of an improper extension cable could result in the risk of fire, electric shock or electrocution. ...
  • Page 5 Our warranty will be voided if the appliance is used in commercial, trade or industrial business or for equivalent purposes. 5. Technical data Model Rated Battery pack Battery pack data Charger model Charger data voltage model RWAC20V1 RWKXBAT20 20V d.c., RWKXCHA20 Input:AC100-240V,50/60Hz 0.5A 2000mAh Output: 21VDC, 0.5A...
  • Page 6 6. Before starting the appliance 6.1 Assembling the appliance  Fitting the handle (Fig. 2) Use a screwdriver to fit the handle (1) with two screws supplied.  Fitting the appliance head (Fig. 3) The appliance head (3) is fastened to the container (5) by the locking hook (4). To remove the appliance head (3), open the locking hook (4) and remove the appliance head (3).
  • Page 7 • When the tool is overloaded: If this occurs, release the trigger switch and remove cause of overload, then pull the switch trigger again to restart. • When the remaining battery capacity becomes low: Recharge the battery pack. Note: The battery protection system does not in any way damage the tool. Note: The indicated capacity may be lower than the actual level during use or immediately after using the tool.
  • Page 8 1 LED is lit: The battery will be empty soon, please recharge the battery. 6.7 Charger indicator Indicator status Explanations and actions Red LED Green LED Ready for use The charger is connected to the mains and is ready for use; there is no battery pack in the charger.
  • Page 9 8.2 Cleaning the appliance head (3) Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning agents or solvents; these may be aggressive to the plastic parts in the appliance. 8.3 Cleaning the container (5) The container can be cleaned with a damp cloth and some soft soap or under running water, depending on the amount of dirt.
  • Page 10 1 Handle 2 On/Off switch 3 Appliance head 4 Locking hook 5 Tank 15L 6 Suction hose connector 7 Suction tube 8 Flexible hose 9 Cartridge filter 10 Charger 11 Battery pack 12 Push lock button 13 Suction hose holder 14 Cartridge filter Pre-filter...
  • Page 12 “Caution - Read the operating instructions to reduce the risk of injury.” Wait at least 24 hours before vacuuming an oven or a fireplace to be sure that the fire has gone out and the ash has cooled down. Only for cold ash, see the operating instructions!
  • Page 13 10. Troubleshooting If the vacuum vibrates abnormally, stop the motor immediately. Abnormal vibration usually indicates a mechanical problem, continued operation could lead to injury or damage. Note: The distributor will not be responsible for any damage or injuries caused by the repair of the vacuum by an unauthorized person or by mishandling of the vacuum.
  • Page 14 11. Disposal and recycling For EU countries only Never place any electric power tools in your household refuse. To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and its implementation in national laws, old electric power tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g.
  • Page 15: Declaration Of Conformity

    2014/30/EU The Electromagnetic Compatibility Directive 2011/65/EU And (EU)2015/863 Restriction of Hazardous Substances Directive Hereby declare that: Equipment ash vacuum cleaner Model number RWAC20V1/ZGMWA-8032015-JZ is in conformity with the applicable requirement of the following documents Ref. No. EN 60335-1:2012+A11:2014+AC:2014+A13:2017+A1:2019+A14:2019+A2:2019 EN 60335-2-2:2010+A11:2012+A1:2013...