Portland MOD-1333 Setup Instructions

© 2024
Order #XXXXX
Steps:
1) Attach base to post, using bolt.
2) Attach plate to top of post, using screw.
NOTE: Plate must rotate left and right before installing clamshell.
3) Attach clamshell to plate, using hex nuts.
4) Connect graphics to A10 clamps. See A10 Clamp
5) Insert iPad into clamshell, then feed cords through holes.
See Cord Management for iPad details.
Cord Management for iPad
Lock
Lock
Clamshell
iPad
Cord
Access
1) Slide connector of clamp
2) Tighten set screw when
3) Insert wing into clamp.
4) Tighten knob on clamp
Attach iPad cord to supplied USB
extension cord. Feed USB cord
through top hole of post, then out
bottom hole of post. Connect to power.
MOD-1333 iPad Kiosk
detail.
A10 Clamp
Connector
Optional Cover for Home Button
into extrusion groove.
A10 is in desired location.
Foam Lining
Removed
to secure wing in place.
1) Remove foam lining from inside bottom of
clamshell.
2) Attach home button shield with double-sided
Set Screw
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
A10 Clamp
NOTE: This is a permanent fix and can't be
Knob
easily removed.
Hex
Nut
Cord from iPad
Graphic
Home Button Shield
Base
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Rotate clamshell
to turn iPad from
portrait to landscape
orientation.
Clamshell
Plate
Completed Kiosk Assembly
Graphic
Post
USB
Extension
Cord