Classic Exhibits SEGUE DESIGNS MOD-1600 Setup Instructions

© 2017
Item Qty. Description
1 2 Base Plate
2/2A 1/1 36"h CEI152 Vertical Extrusion
3/3A 1/1 36"h CEI152 Vertical Extrusion
4/4A 1/1 42"w CEI152 Horizontal Extrusion
Steps:
1) Install Base Plates [1] to bottom of horizontal [4] using bolts.
2) Assemble verticals [2-2A] & [3-3A] together.
See CEI152 Straight Connection detail.
3) Connect horizontals [4,4A] between vertical assemblies [2/2A]
& [3/3A]. See CEI152 Corner Connection
4) Attach power cords to Supernova lights as shown.
5) Apply SEG graphic & blocker to assembled frame.
SEG Graphic Installation
Corner A
Corner B
Corner D
Corner C
It is important to first insert
Step 1
graphic into each alternate Insert corner A. Turn edge of
corner then to the sides of graphic so silicon welt is
the frame. If this is not done,
perpendicular to face of
graphic will not fit into the graphic. Insert narrow side
frame correctly. of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
w w w . c l a s s i c e x h i b i t s . c o m
MOD-1600 48"x76" Lightbox
Order #XXXXX
*
2A
detail.
*
2
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
*
Graphic Removal
1
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
4A
*
Power
Break
Power
Break
3A
*
*
4
1
SETUP INSTRUCTIONS
Light to Light Attachment
Male
+
+
Lights
-
-
Light to Tranformer Attachment
+
- Female
Power
Transformer
Maximum of 7 lights per chain,
9 lights per Transformer
* CEI-152 Corner Connection
A1
1) Insert TSRV2 and A1 Brackets
into milled groove of extrusion.
2) Slide connecting extrusion over
exposed end of brackets.
3) Use Set screws to secure
3
*
CEI-152 Straight Connection
3) Use Set screws to secure
extrusions.
When assembled
TSRV2
Bracket
extrusions.
4) Use Set screws to secure
extrusions.
1) Insert TSRV4 Bracket
into milled groove of
Extrusion.
2) Slide connecting extrusion
TSRV4 over exposed end of bracket.
Bracket
Set
Screws