Advertisement
Quick Links
01/08/2022 Ver 1.0
Safety Regulations and Important Warnings
!
Please read all operating and maintenance (servicing) instructions in the literature accompanying this
equipment. If these instructions are not followed exactly, possible bodily injury may occur.
MATRIX FRAME EXTRA - Installation Manual
MATRIX FRAME EXTRA
Installation Manual
Copyright © MATRIX-CABINET 2015. All Rights Reserved.
This document contains information of commercial value, proprietary
of MATRIX-CABINET. It is prohibited to copy, use, or transfer this
document and/or any part thereof to anyone without the prior written
permission of MATRIX-CABINET.
Page 1
Advertisement
Summary of Contents for Matrix FRAME EXTRA
- Page 1 Copyright © MATRIX-CABINET 2015. All Rights Reserved. This document contains information of commercial value, proprietary of MATRIX-CABINET. It is prohibited to copy, use, or transfer this document and/or any part thereof to anyone without the prior written permission of MATRIX-CABINET.
- Page 2 The MATRIX FRAME unit is suitable for mounting on wall only. To avoid shock, do not perform any non-authorized servicing. Disconnect the product from the power line before removing covers. Any adjustment and maintenance of the opened device should be done only while the device is disconnected from its source of power and should only be performed by qualified personnel.
-
Page 3: Product Specification
General This document contains an overview of the MATRIX FRAME EXTRA unit major hardware parts and provides a step by step installation The MATRIX FRAME EXTRA is a wall mounted unit with configurable bins structure. The unit is fully controlled by a dedicated PC offering highest level of security and management. - Page 4 1) Mark the recommended height of 1.83m (72inch) from floor at the center of the unit 2) Drill the center hole and connect the mounting panel. Use a leveler and mark the 4 remaining holes MATRIX FRAME EXTRA - Installation Manual Page 4...
- Page 5 3) Drill and connect the other 4 screws tightly 4) Take the FRAME EXTRA unit out of the package MATRIX FRAME EXTRA - Installation Manual Page 5...
- Page 6 Press the lock inside to retract the metal latches that hold the plastic cover on the bottom side, and while keeping it pressed pull the plastic cover away from the bottom of the unit. MATRIX FRAME EXTRA - Installation Manual Page 6...
- Page 7 Continue and pull upwards from the sides and finally remove from the top to completely take the cover off. c. Drill and connect another screw on the bottom right side. Make sure not to damage the wires and electronics! MATRIX FRAME EXTRA - Installation Manual Page 7...
- Page 8 Release the lock and verify that the two metal latches on the bottom slide into the corresponding openings on the cover bottom. Take out the key by turning it 90 degres clockwise to locked position MATRIX FRAME EXTRA - Installation Manual Page 8...
- Page 9 7) Connect the supplied power cable to the socket and plug it to the power inlet at the right side of the unit MATRIX FRAME EXTRA - Installation Manual Page 9...
- Page 10 – enables software updates and remote support Connect the supplied network cable to the network port marked "Internet" located on the right side of the unit MATRIX FRAME EXTRA - Installation Manual Page 10...
- Page 11 Continue and pull upwards from the sides and finally remove from the top to completely take the cover off. MATRIX FRAME EXTRA - Installation Manual Page 11...
- Page 12 3. On each one of the two bin units, press the metal bar to the left of the bins upwards. Gently press the metal lever, which is located below each column of bins, while still holding the metal bar up, to manually open this column of bins. MATRIX FRAME EXTRA - Installation Manual Page 12...
Need help?
Do you have a question about the FRAME EXTRA and is the answer not in the manual?
Questions and answers