01 On the Wall Step 1:Install the wall-bracket on the wall. Step 2:Install the kiosk-bracket. Note: You can find the wall bracket and kiosk bracket in the shipping package.
Page 5
01 On the Wall Step 3: Plug in power cable and net Step 4: Align the holes and hang the kiosk on cable. the wall-bracket, and screw the two brackets together.
03 On the Stand Step 1: Thread the power cable and Step 2: Install the wall-bracket. net cable through the route in the stand.
Page 8
03 On the Stand Pull the kiosk Step 4: Hang the kiosk on the wall-bracket , and Step 3:Install the kiosk-bracket. pull the kiosk aside to plug in the cables.
Page 9
03 On the Stand Step 5: Screw the two brackets together.
Page 10
04 On the Cabinet Step 1: Thread the power cable and net Step 2: Install the wall-bracket. cable through the route in the cabinet.
Page 11
04 On the Cabinet Pull the kiosk Step 4: Hang the kiosk on the wall-bracket , and Step 3:Install the kiosk-bracket. pull the kiosk aside to plug in the cables.
Page 12
04 On the Cabinet Step 5: Screw the two brackets together.
Page 13
Verify Install ⚫ Steps to test stability 1. Depending on the way the fixed equipment is used on the customer’s onsite; 2. Refer to Page4 Step4 or Page8 Step4 or Page12 Step5;Firstly, hang the device on the wall bracket to see if the overall level is horizontal; 3.
Page 14
05 Power supply suggestion ⚫ In the installation site, need to provide independent power supply for the self-checkout Input: AC 110~220V power supply, ground wire must be connected to the earth; Between the main power supply and the self-service terminal, it should be protected by leakage protection switch. ⚫...
Need help?
Do you have a question about the MT-2420 S and is the answer not in the manual?
Questions and answers