Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EasyWater ACID SHIELD AS 1000
Summary of Contents for EasyWater ACID SHIELD AS 1000
- Page 1 Installation & Service Manual...
-
Page 2: Table Of Contents
Table of Contents Unpacking & Inspection ................................Basic Guidelines . -
Page 3: Unpacking & Inspection
Be sure to inspect the entire shipment immediately upon receipt for any shipping damage or parts loss. Also note any damage to the shipping carton. Contact the transportation company for all damages and loss claims. EasyWater is not responsible for damages in transit. Basic Guidelines »... -
Page 4: Specifications
Specifications Optimal Min Backwash Maximum Model Tank Size Flow Rate Flow Rate Pressure < 8 gpm 5 gpm 120 psi AS 1000 10” x 54” < 12 gpm 12 gpm 120 psi AS 2000 13” x 54” 7.5” 2” All 10” All 13”... -
Page 5: Before Starting Installation
Before Starting Installation WHERE TO INSTALL THE FILTER » Place the filter as close to the incoming water line as possible. On well water applications, this would be as close as possible after the pressure tank. If you desire to bypass outdoor faucets in order to conserve water and filter capacity, install or plumb as necessary. -
Page 6: Plan How You Will Install The Filter
If a lawn or garden irrigation system or open loop heating/cooling system is to be treated, a separate Acid Shield will be necessary. Contact EasyWater Tech Support for more information on these installations. Acid Shield | Installation & Service Manual... -
Page 7: Installing Valve Head On Tank
Before Starting Installation (Cont’d) INSTALLING VALVE HEAD ON TANK DO NOT exceed 25 ft lbs of torque when installing this product. Exceeding this limit may damage the threads and cause failure. DO NOT use the drain connector to tighten the valve on the tank. -
Page 8: Setting The Controller
Setting the Controller The EasyWater Acid Shield uses an electronic controller to manage the valve head, and the regeneration and backwash processes. When the unit is in the “Service” position (the unit is providing treated water), the display will alternate between showing the current time of day and the days between regeneration. The regeneration cycle is preset to occur at 12:00 AM every second or seventh day. - Page 9 NOTE: If you use water during the 61-81 minute regeneration period the water will be untreated by the EasyWater Acid Shield. a. Press and hold the REGEN button for three seconds. Open two faucets inside the home.
-
Page 10: System Start-Up
System Start-Up (After installation is complete) Open two faucets inside the home. Turn the bypass valve to the service position. Fill the filter with water by turning on the water service valve SLOWLY. Close the two open faucets inside the home. Check installation for leaks. - Page 11 Replenishing the Filter Media Close the homes main water service valve. Open nearest treated faucet to relieve water pressure and drain plumbing line. Place Acid Shield system into the Bypass position. Carefully unscrew and remove mineral tank cap exposing the dome hole. Be ready with a container to catch the small amount of water that escapes from the unit.
-
Page 12: Troubleshooting
Troubleshooting Problem Possible Cause Solution System Does Not No power Ensure unit is plugged in and receiving Backwash power Ensure system is not on a switch that gets turned off Power failure Reset time of day and check settings Defective motor Replace motor System is Not Drain line is kinked... -
Page 13: Limited Warranty
EasyWater Authorized Partner Dealer, contact EasyWater, Inc., at (888) 766-7258 or via email at info@easywater.com. We will repair or replace the part at no cost if our repair department determines it to be defective under the terms of the warranty.
Need help?
Do you have a question about the ACID SHIELD AS 1000 and is the answer not in the manual?
Questions and answers