Overview Connectivity Installation System Cabling Cabling Example Menu Menu Order Menu Selection Info Manual Patch QuickPatch ArtNet QuickPatch DMX Combine- and Repeat Modes Setup Menu Output Type Colour Gain Test Menu Manual RGB ArtNet Monitor ArtNet Test Mode Demo Mode Fast/Slow Factory Defaults Error Messages Software Update...
Once again with these products each LED can be individually controlled. It is also possible to use the System Power Supply 4E as a stand-alone unit, without a DMX or ArtNet control signal. The System Power Supply 4E can also supply all Series B products by Schnick-Schnack-Systems.
After approximately one second the System Power Supply 4E is ready for use. If the System Power Supply 4E has been taken from a cold environment into a warm interior after transportation, allow Keep the unit out of direct sunlight at all times.
Menu The following connections are located on the front of QUIT the unit: SHIFT DOWN EDIT ENTER UP SHIFT+ QUIT used in conjunction with... exists the currently-selected mode EDIT to move the cursor backwards through ENTER to confirm certain actions e. g. mode changes the data fields moves upward through the mode list.
Menu Order Temp. Main Menu: Welcome to Systemnetzteil 4E Info v 2.6 Main Menu: Manual Patch Main Menu: QuickPatch ArtNet Main Menu: QuickPatch DMX Main Menu: Setup Menu Main Menu: Test Menu Main Menu: Factory Defaults * Output Typ S3-DMX: Manual Patch and QuickPatch DMX are not necessary...
QUIT button to return to the most recently used mode. Info This mode displays the unit type and installed Temp. software version. Welcome to Systemnetzteil 4E v 2.6 Manual Patch When changing from the QuickPatch mode into the Manual Patch mode the following display is shown:...
QuickPatch ArtNet For each output two data fields are shown on the display. OUT 1 OUT2 OUT3 OUT4 The upper field displays the ArtNet universe as a decimal number. Universe Enter Start-Ch: The lower field displays the DMX start address for the universe in the data field above it (if the information of a universe may need to be patched across more than one output).
Combine and Repeat Modes OFF: no combine ALL: all LEDs are steered by three DMX channels always two LEDs are interconnected always three LEDs are interconnected always four LEDs are interconnected always five LEDs are interconnected always six LEDs are interconnected always seven LEDs are interconnected always eight LEDs are interconnected always nine LEDs are interconnected...
Setup Menu The Setup Menu is divided into: Setup Menu: Output Gain Output Type Switch between standard DMX 512 or S3-DMX for the enterprise of the LED-Tiles C25 or LED-Panels C60-25. Output Type: DMX 512 Like the other modes, use the EDIT button to select the required field and the UP/DOWN buttons to set the required values.
Test Menu The Test Menu is divided into: Test Menu: Manual RGB Test Menu: ArtNet Monitor Test Menu: ArtNet Test TX Test Menu: Demo Slow Test Menu: Demo Fast Manual RGB This mode allows a static, single colour to be set across all Manual Colour Mode connected illuminants, without the need for an incoming DMX signal.
0.0Hz Monitor This feature allows to test the frame rate of the respective ArtNet signal. ArtNet Test Mode In this mode the System Power Supply 4E will function as an ArtNet Test Mode ArtNet data transmitter. Toff #uni State This function was implemented as a means of testing the 0.50...
In this mode all connected RGB LEDs will run a preset se- quence at one of two speeds selected by the user. Demo Mode Fast Please note that separate System Power Supply 4E running this mode will not run synchronization with each other. Demo Mode Slow...
Factory Defaults Push SHIFT+ENTER. Then the equipment puts back to factory settings. Restore Factory Defaults? Quit Shift+Enter Error Messages If one of the fuses protecting the outputs should fail, the Output Error display will flash and show the following type of message. OUT 1 OUT2 OUT3 OUT4 In this case output is 1 failed.
PLEASE WAIT 5. When the installation is complete the display shows the welcome message and the new software version number 6. The System Power Supply 4E is now ready to use again 7. Removing the SD card...
Technical Data 19“, two height unit Housing 483 x 88 x 430mm (WxHxD) Dimensions 100-250V AC, 50-60Hz Input voltage 700VA Power Consumption 6A per output maximum Current Output IEC plug, lockable Main Connector DMX 512 A-1990 USITT Data Protocol Neutrik XLR5-Pin DMX IN Neutrik XLR5-Pin DMX THROUGH...
Page 26
We are a supplier who delivers high-quality reliable systems –under tight deadline constraints that are not only quick to install but simple to operate and service also. Schnick-Schnack-Systems GmbH Mathias-Brüggen-Straße 79 50829 Cologne (Germany) Phone: +49 (0) 221/99 20 19-0 Fax: +49 (0) 221/16 85 09-73 info@schnickschnacksystems.com...
Need help?
Do you have a question about the 4E and is the answer not in the manual?
Questions and answers