Advertisement
Advertisement
Table of Contents
Related Manuals for Ronix 2450
Summary of Contents for Ronix 2450
- Page 1 CONCRETE MIXER 2450...
-
Page 3: Technical Specification
TECHNICAL SPECIFICATION 2450 Model Motor Power 850W Motor Type Induction Voltage 230V Frequency 50Hz Drum Capacity 200 Lit Drum Rotation Speed 32 RPM Drum Thickness Upper1.2mm/lower1.8mm Drum Material Steel Drum Diameter 618mm Drum Size Upper 340mm/lower 325mm Drive Type Belt Stand Size 1165×700×1370mm... -
Page 4: Part List
PART LIST Drum Motor Cover Adjusting Plate Ring Gear Box Foot Wheels GENERAL POWER TOOL SAFETY WARNINGS SYMBOLS Please read and maintains this manual. Use hearing protection. Use a mask. Use eye protection. CONCRETE MIXER... -
Page 5: Electrical Safety
Wear safety shoes. Warning / Attention! Danger of electric shock! WARNING READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS! Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING! Save all warnings and instructions for future reference. The term "power tool"... -
Page 6: Personal Safety
Water entering a power tool will increase the risk of electric shock. d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. - Page 7 the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool.
- Page 8 OPERATING INSTRUCTIONS NOTE: All parts below refer to the parts list. CAUTION! 1- Do not attempt to move the Cement Mixer when it is full or in operation. 2- Place the Cement Mixer on a solid, flat, and level surface that is capable of supporting the weight of the mixer and its load.
-
Page 9: Maintenance And Cleaning
12- When finished, make sure to thoroughly clean the inside of the Drum. MAINTENANCE AND CLEANING CAUTION! 1- Never perform any services or maintenance on the Cement Mixer while it is running. Before performing services or maintenance, turns off the engine and disconnect the spark plug wire to prevent accidental starting. - Page 10 WARNING! Dangerous mains voltage! Danger of electric shock! Before cleaning, always remove the plug from the mains socket. - Clean ventilation slits with a brush. - The tool is permanently lubricated and does not require oiling. CONCRETE MIXER...
Need help?
Do you have a question about the 2450 and is the answer not in the manual?
Questions and answers