Summary of Contents for Fractal FR-482C1DRNAJ
- Page 1 Quick Start Guide FR-482C1DRNAJ & FR-802C1DRNAJ Suite 210 5-420 Erb St. W. Waterloo, On, N2L 6K6 Canada Phone: +1 (519) 404-2810 • www.fractalev.com • contact@fractalev.com...
-
Page 2: Box Contents
IMPORTANT SAFETY INSTRUCTIONS Charger Quick Start FR48C/FR80C WARNING – When using electric products, basic precautions should Note: This charger should be registered at www.FractalEV.com for online always be followed, including the following. This manual contains visibility and configuration. Certain features are only available from the important instructions for Models FR48C and FR80C that shall be FractalEV Portal. - Page 3 Icon Reference Before you leave the site verify the checklist: Networking Icons can be found at the top of the Driver’s Help Screen, and Done Item on any Settings Screen. Onsite Charger registered to the appropriate FractalCloud account. Wifi Network OCPP Connection If not, record the following information: Serial Number ___________________________________...
-
Page 4: Installation Procedure
Installation Charger State Display LED Color Display Description Text LEDs off Charger is not yet ready or is powered off Solid Green Ready Charger is available for use Blue/Green Plugged- Charge session has been authorized by 1 second in, or user, but vehicle is not plugged in, or Installation Procedure spin... -
Page 5: Electrical Installation Requirements
Electrical Installation Requirements For ¾”-sized Conduit: use the appropriate reducing washers along with rubber seals. For rear power entry: Ensure all connections are powered off before beginning installation. Install the supplied “Bottom Entry Plug” into the bottom-entry cable gland, and tighten to seal it. Select conductor and ground wire sizes in accordance with all local Locate the rear entry port - The center hole is pre-marked for regulations for the installed circuit breaker if operating at less than... - Page 6 Mount the Charger Ring Terminal Selection Chart: Using a 4mm hex wrench, remove the Mounting Bracket from the Use Ring Color Supplied Supplied charger. Terminal with FR48C with FR80C At the designated location, use provided screws or suitable fasteners to affix the Mounting Bracket to the wall. 10-12 RNYM5-6 Yellow...
- Page 7 Minimum Settings to operate the charger *If Enable PowerShare Follower Mode is checked, then the charger will be limited to the Fallback Amperage until the entire group has been configured in PowerShare. Refer to the Complete Installation Guide for Before the charger can be used, it must have Amperage Settings. Once detailed instructions to set up PowerShare.
-
Page 8: Factory Reset
Charger Networking Wifi Credentials On the Networking Settings page, click Setup Wifi. From here, the Wifi FR48C and FR80C both support 3G/4G multi-carrier connectivity, as well as 2.4Ghz Wifi. Both networking interfaces may be enabled function can be disabled, you can clear the stored Wifi credentials, or you simultaneously, the charger will automatically switch between the two, can attach to the list of available networks. - Page 9 User Manual Warning Statements This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the FR-482C1DRNAJ and is the answer not in the manual?
Questions and answers