Advertisement
Quick Links
Advertisement
Related Manuals for Morfit Original
Summary of Contents for Morfit Original
- Page 1 Morfit Original ® Adjustable Back Support USER MANUAL...
-
Page 2: Health And Safety
IMPORTANT INFORMATION The use of any lumbar support device involves a potential risk to the user if the device is not used properly. We therefore strongly advise you to take the following steps when using Morfit back support. Ensure that you have read and understood the advice and instructions in this user manual before using Morfit. - Page 3 YOUR MORFIT ® VERTICAL BUNGEE STRAP HORIZONTAL STRAP TUBE MORFIT BACK SUPPORT STOPCOCK PUMP...
- Page 4 SET UP AND USER INSTRUCTIONS 1. Check your seat position • Recline your seat-back a notch or two from vertical. This lets the seat take some of your weight, rather than placing it all through your spine. • Adjust the seat forwards or backwards so that there is a slight bend in your knee when the pedals are fully depressed.
- Page 5 3. Morfit set up Open the stopcock: turn the blue handle so that it is at a right-angle to the tube. Connect the stopcock to the long pump nozzle. Pump 15-20 times. Leaving the pump attached, lean slightly forwards, away from Morfit. Using both hands, shake Morfit up and down for 5 seconds to distribute the filling.
- Page 6 Lean back and sit in good posture. Detach the stopcock from the pump, some air will escape – that’s OK. Tip: pull the stopcock with a gentle quarter-turn twisting action. Maintaining good posture, lean back and wriggle firmly into Morfit to mould it to your shape, removing any lumps and bumps.
- Page 7 Attach the stopcock to the short pump nozzle. Pump 10-15 times. Close the stopcock by turning the handle to line up with the tube. Detach the stopcock from the pump and store until you want to reset Morfit. Tip: pull the stopcock with a gentle quarter-turn twisting action.
- Page 8 4. Attach Morfit to your seat Loop the vertical bungee strap around the head rest. Adjust the vertical bungee, so that Morfit hangs at the correct height for you. Optional: Attach horizontal straps* around the back of the seat to help keep Morfit in position. (Don’t attempt this when seated –...
- Page 9 5. Safety warning The horizontal straps are optional and do not improve the effectiveness of Morfit. They prevent sideways movement of Morfit when getting in and out of the vehicle. DO NOT use Morfit’s horizontal straps if they cover any airbag ports on the side of your seat.
- Page 10 GETTING THE MOST OUT OF MORFIT Find the best fit For your first 10 trips, it’s a good idea to practice resetting Morfit every time you go on a drive. This will help you find the right fit. Check the position on every trip We highly recommend that you take a second to place Morfit into its exact...
-
Page 11: Legal Information
Washing the cover Remove inner bag unit by reaching through one of the pockets on the back. Hand wash only. Do not tumble dry. Wait until it’s 100% dry before reassembling. When reassembling ensure the bead side of the inner bag unit is facing forward and is against the front fabric. Changing the tube exit side If you prefer the tube to come out from the other side of your Morfit simply find the two pockets on the rear of the cover. -
Page 12: Customer Support
Warranty of condition Morfit back support is covered by a one year warranty against defective parts and workmanship. This warranty is subject to our Terms and Conditions, which can be viewed on our website. WARNING: This warranty covers defects in materials and workmanship only.
Need help?
Do you have a question about the Original and is the answer not in the manual?
Questions and answers