Apex Digital APX-GTSA Series Quick Start Manual

THERMOSTAT (3 SPEED FAN COIL) +
FOUR SCENES BUTTON
PRODUCT INTRODUCTION
The APEX smart thermostatic keypad is an
intelligent device that can be remotely controlled
through the Z-Wave network (800 LR Series). In Z-
Wave network communications, this product can
be connected to any standard Z-Wave gateway.
This product has four touch buttons with two
actions (long press and short press). The RGB
backlight status color for each button and icons can
be swap by dealer without any machine.
WWW.SMARTAPEX.ES
SPECIFICATIONS
Model number APX-GTSA-XXX
Power requirement 100 to 240VAC / DC24V /AC+0-10V
Power consumption <1W
Frequency 868.4MHz EU (optional)
Z-wave Series 800 LR
-10 to +70 ̊ C
Operational
temperature
Humidity 5% to 90% non-condensing
Weight 0.2 kg
Material Tampered Glass / Aluminum
Standard Size 86x86m EU size
1.5A per inductive output
Fan Load (coils current)
ADD TO Z-WAVE NETWORK
1. Connect the device to a power source
2. Make sure LED status lights are fixed
3. Touch and hold the last button for 4 seconds,
blue LED indicators start blinking (note that the
gateway must be in identification mode). When
identifying mode starts, the blinking color goes
green and waits to complete joining. 4. When
joining is completed, all LED lights will be fixed.
REMOVE FROM Z-WAVE NETWORK
1. Make sure the device is powered.
2. Set Z-Wave gateway into exclusion mode
(Refer to gateway user manual)
3. Touch and hold the last button for 12 seconds,
red led lights will be blinking. If the gateway is
in exclusion mode, the device will be removed
from the network.
RESET TO FACTORY SETTING (Network reset)
Touch and hold the last button for 12 seconds, red
LED lights will be blinking then release the button
and press and hold for more 12 seconds. The light
switch will restart and finish.
QUICK REFERENCE
Buttons Description
Thermostat on/off button
WHILE THERMOSTAT IS ON:
LONG PRESS FOR 3 SEC: change mode (cool,
heat, fan)
WHILE THERMOSTAT IS OFF:
LONG PRESS FOR 3SEC: active or deactivate
temperature display on OFF mode
Increase or decrees temperature set point
Fan coil speed control: low, medium, high or
Auto
LONG PRESS FOR 5SEC: enable or disable
temperature display LOCK
SERVICE
Your Thermostatic keypad switch carries a
24-month warranty from the date of purchase.