The appliance is FOR OUTDOOR USE ONLY. It is not to be used inside a garage, other building or any type of enclosed area. WARNING: • All MHP Grill Heads may be mounted on the column. • The gas supply may be either LP or Natural •...
Page 3
CONNECTING THE TANK LOCK BAR STEP 1 PARTS NEEDED TOOLS NEEDED HARDWARE NEEDED GGOCOLRB GGOTB 7/16" OPEN END GGM4 GGM6 GGOTBS STAINLESS STEEL TANK LOCK BAR KEP NUTS (2) 1/4 X 20" X 3/4" NYLON TANK COLUMN HEX BOLTS (2) BAR SPACERS Locate the Tank Lock Bar from the OCOLB Box •...
Page 4
ATTACH THE BASE TO THE COLUMN (OC BASE) STEP 2A-OC PARTS NEEDED FROM OC BOX Included with natural gas bases only GGAXL GGGC GGWL1 OCOL ASPCL1 CAST ALUMINUM BASE AXLE AXLE CLIPS (2) 6" WHEELS (2) HUB CAPS (2) 12' NATURAL GAS HOSE (Quick Disconnect HARDWARE NEEDED...
Page 5
STEP 2B-OM ATTACH THE BASE TO THE COLUMN (OM BASE) PARTS NEEDED FROM OM BOX HARDWARE NEEDED GGM4 GGM11 KEP NUTS STAINLESS STEEL WASHERS GGAXL OCOL (QTY. 6) (QTY. 12) CAST ALUMINUM BASE AXLE HUB CAPS (2) GGM15 GGM6 GGGC GGWL KKWL RECTANGULAR WASHERS...
Page 6
STEP 2B-OM ATTACH THE BASE TO THE COLUMN (OM BASE) continued PARTS NEEDED ATTACH WHEELS • For accessibility, lay the column on it's side. • Attach the wheels by slipping the axle through the pre-drilled holes in the base, slide the wheels onto the axle and secure with the axle clips. •...
Page 7
STEP 2C-OP ATTACH THE BASE TO THE COLUMN (OP BASE) PART NEEDED TOOLS NEEDED ADDITIONAL ITEMS NEEDED FOR PATIO BASE INSTALLATION Included with (Not Included) natural gas bases only 7/16" OPEN ADJUSTABLE OP BASE GGCTSS END WRENCH WRENCH CAST ALUMINUM BASE FLEX TUBE 3/8"...
Page 8
Use appropriate Lag Bolts for your application LAG BOLTS (2) Not supplied by MHP SECURE THE BASE (FOR LP GAS INSTALLATIONS) • Choose a location where you are going to set up your grill. Make sure the surface is flat and...
Page 9
STEP 3 CONNECT THE GRILL HEAD BOTTOM If you are using an OP Base the grill head should not be attached to the column until the base has been permanently mounted to a deck or patio surface. If this has not been done, see step 3X-OP for steps to secure the OP base. HARDWARE NEEDED TOOLS NEEDED GGM14...
Page 10
(QUICK DISCONNECT) supply line's shut-off valve. Depending on the size of your gas line you may need a reducer (not supplied by MHP) to connect your gas line to the quick GAS VALVE disconnect socket (3/8" male pipe thread). •...
Page 11
(QUICK DISCONNECT) supply line's shut-off valve. Depending on the size of your gas line you may need a reducer (not supplied by MHP) to connect your gas line to the quick GAS VALVE disconnect socket (3/8" male pipe thread). •...
Page 12
STEP 4C-OP CONNECTING THE GAS SUPPLY LINE (OP BASE) CONNECT THE GAS LINE (FOR LP GAS INSTALLATIONS) • The LP Hose and Regulator are factory-installed onto your grill head's LP Valve • Attach the LP Regulator to your propane tank and securely hand tighten the coupling nut to the cylinder valve. •...
Page 13
(Not supplied by MHP) Attach Natural Gas Line to the GGCTSS Flex Tube • Connect a 3/8" flare coupling (not supplied by MHP) to the GGCTSS gas supply line then the flexible stainless-steel tubing (GGCTSS) using a 3/4" wrench. The use of two wrenches is recommended—one wrench is used to hold fitting while the...
Page 14
STEP 5 ATTACHING THE ACCESS PANEL Do not attach the front access panel until the control panel has been attached to the grill head bottom and the gas supply line has been properly connected and leak tested. Attach the Access Panel Cover •...
Page 15
, juice or marinade. flips everytime. Features a solid wood box designed to work with all MHP beverage can easily fit in the can grip handle and a sturdy stainless Grills. Insert moistened wood chips support ring.
Make the most out of your grilling experience! From side burners and rotisseries to grill covers and more— we carry a complete line of grill upgrades, accessories and grill parts designed specifically for your MHP Grill. Visit MHPGrills.com for more information TECHNICAL SUPPORT Modern Home Products 150 South Ram Road •...
Need help?
Do you have a question about the OCOLB Series and is the answer not in the manual?
Questions and answers