Do you have a question about the Tete-a-tete Double Chair Wood Rounded and is the answer not in the manual?
Questions and answers
Summary of Contents for Comfy Chair Tete-a-tete Double Chair Wood Rounded
Page 1
Barneveld, Netherlands Phone: + 31 6 51920965 E-mail: info@comfychair.nl Website: www.comfychair.nl Wood Tete-a-tete PACKAGE CONTENT PACKAGE CONTENTS Double Chair Original Chair Wood Rounded CCC100 Note: on this page, you will an overview of the components of one chair. In total, the double chair contains two of these chairs. L1-7 Bottom side...
Page 3
Barneveld, Netherlands Phone: + 31 6 51920965 E-mail: info@comfychair.nl Website: www.comfychair.nl Tete-a-tete Assembly instructions Double Chair Wood Before you start • Carefully unpack the package and check if all components are present. • Required for assembly: cordless drill, hammer and an wrench 13.
Page 4
Barneveld, Netherlands Phone: + 31 6 51920965 E-mail: info@comfychair.nl Website: www.comfychair.nl Tete-a-tete Assembly instructions Double Chair Wood Step 3 | Front chair legs and high back sup- port • Place chair leg E on the outside of side piece A, with the rounded side facing down and the countersunk holes facing in.
Page 5
Barneveld, Netherlands Phone: + 31 6 51920965 E-mail: info@comfychair.nl Website: www.comfychair.nl Tete-a-tete Assembly instructions Double Chair Wood Step 6 | High back support • Place the high back support J on top of the planks F with the rounded side facing inwards and the countersunk holes facing up.
Page 6
Barneveld, Netherlands Phone: + 31 6 51920965 E-mail: info@comfychair.nl Website: www.comfychair.nl Tete-a-tete Assembly instructions Double Chair Wood L1-7 Step 9 | Back slats • Place the remaining back slats in their proper places. • Fasten the slats at the bottom with 4x40 mm screws.
Page 7
Double Chair Wood Step 12 | Repeat Repeat the previous steps to assemble the second Comfy Chair. After this, proceed to assemble the table. The assembly of the table Step 1 Secure the two inner armrests with a 4 x 30 mm screw and allow the armrests to protrude in the middle by about 2.5 cm.
Page 8
You can correct this by sliding the armrests. If everything fits together nicely, you can screw everything together. Done! After the work is done, it is good to rest ... in your Comfy Chair Double Chair. Enjoy!
Need help?
Do you have a question about the Tete-a-tete Double Chair Wood Rounded and is the answer not in the manual?
Questions and answers