Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for eSSL PL10D
Summary of Contents for eSSL PL10D
- Page 1 Security at Fingertips Installation Manual PL10D / ML10D www.esslsecurity.com...
-
Page 2: Installation Instruction
Installation Instruction PL10D/ML10D Version: 2.0... -
Page 3: Before Installation
Before Installation Diagram... -
Page 4: Packing List
Packing List Mounting Hardware Package Mounting Hardware Package for door thickness of 39-46mm for door thickness of 47-54mm 64mm 35mm 40mm 30mm 35mm... -
Page 5: Door Preparation
Door Preparation 1. Check the door thickness and prepare the corresponding mounting hardware package. Door Thickness H Spindle Length J Screw Length M Screw Length L Screw Length (mm) (mm) (mm) (mm) (mm) 30~38 39~46 47~54 55~60 Note: The standard lock includes 2 mounting hardware packages only, which are used for the door thickness of 39-46mm and 47-54 mm separately. - Page 6 3. Change latch (D) direction. Remove screws from the latch trim panel with a Fix the latch trim panel by using screws. screwdriver and rotate the latch bolt at 180°. How To Use Key & Change Handle Direction? How To Use Mechanical Key And Change Handle Direction? Hexagon Screw...
- Page 7 Remarks 1. New lock is configured to grant any fingerprint access. 2. The lock is equipped with mechanical keys for manual unlocking. Remove mechanical keys from the package and keep them in a safe place. 3. To power up the lock, four alkaline AA batteries (not included) are required. Non-alkaline and rechargeable batteries are NOT recommended.
-
Page 8: Installation
Installation 1.Drill holes on the door. 2.Install the latch (D). center line of the handle desired handle height 1) Align the template along the vertical center line of the latch(D) at the desired handle height, and tape it to the door. 2) Mark the holes first, and then start drilling. - Page 9 3.Install outdoor unit (B) with gasket (C) and spindle (H) on the door. Correct Position: The small triangle must be vertically upward. This position is wrong.
- Page 10 4.Install mounting plate (I) with gasket (C) on the door. 5.Install indoor unit (K). Note: Push cable into the hole first.
-
Page 11: Insert Batteries
6.Insert batteries. 7.Mark and drill holes for the strike. 24 mm 22 mm [55/64"] [19/64"] 8. Test the lock by rotating the back handle and using the mechanical Key (A). Note: 1) When the door is locked and the clutch is idle, the front handle can be turned, but the door will remain locked. - Page 12 #24,Shambavi Building, 23rd Main,Marenahalli, JP Nagar 2nd Phase, Bangalore - 560078 Phone: 91-8026090500 | Email : sales@esslindia.com www.esslsecurity.com...
Need help?
Do you have a question about the PL10D and is the answer not in the manual?
Questions and answers