Advertisement
Quick Links
Advertisement
Summary of Contents for OZpig OZP-FP022-01
- Page 1 3-in-1 Flat Pack Fire Pit INSTRUCTION MANUAL PART NO. OZP-FP022-01...
- Page 2 IMPORTANT: Read these instructions for use carefully. Familiarise yourself with the appliance before use. Keep these instructions for future reference. WARNING Keep the Fire Pit in a level position at all times. Always use appropriate tools and cooking implements with long heat resistant handles. Never touch the surface of the Fire Pit to test if hot.
-
Page 3: Safety Information
OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL SAFETY INFORMATION • CAUTION: All care and maintenance • DO NOT store or use petrol or other procedures are to be performed only while flammable liquids in the vicinity of this or the Fire Pit is cold. - Page 4 SAFE APPLIANCE LOCATIONS This appliance shall only be used in an Example 2 above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: •...
- Page 5 OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL UNDERSTANDING THE 3-IN-1 FLAT PACK FIRE PIT 3 x Rack supports 2 x Ventilation plates 2 x Flame side plates 2 x Stabilisers 1 x Carry bag 2 x Ozpig support plates...
- Page 6 3-IN-1 FLAT PACK FIRE PIT CONFIGURATIONS Low Fire Pit Configuration Raised Fire Pit Configuration Fire Ring Configuration...
- Page 7 OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL SET UP LOW FIRE PIT SET UP PARTS 2 x Flame side plates 2 x Ventilation plates 1 x Base plate ASSEMBLY Insert one end of the base plate into the slot of a flame side plate. Ensure that the cylinder rotisserie brackets are facing outwards.
- Page 8 Assemble the top part of the fire pit as per the Low Fire Pit set up. To assemble the support rack, position the two (2) Ozpig support plates and insert one (1) rack support into the slot on each support plate.
- Page 9 OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL SET UP FIRE RING SET UP PARTS 2 x Flame side plates 2 x Ventilation plates 2 x Ozpig support plates ASSEMBLY Working in a circle, start with one (1) Ozpig support plate and slot in one (1) Flame side plate.
- Page 10 BURNING IN THE PAINT FIRE UP It is important to burn in the Fire Pit on first 1. Set up the Fire Pit in a level position. Requirements: use. • Kindling The paint on the Fire Pit needs to reach over •...
-
Page 11: Specifications
OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL FIRE TIPS CARE & MAINTENANCE A good fire needs good air flow. This is INFORMATION key throughout the burn, not just at the beginning. Ensure adequate air flow each time fresh timber is added to the fire. - Page 12 RECIPES CHARGRILLED STEAK Ingredients Tips • Steak (choose preferred cut) • Preheat the cooking plate to get an • Cooking oil instant char to create a crust which adds extra flavour and texture. • Salt and pepper • Chargrilling works best with a good bed of coals.
- Page 13 OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL RUMP CAP (PICANHA) Ingredients Tips • 1.2 - 1.5kg Picanha (or rump cap) • It is important to evenly balance and centre the meat on the rotisserie. The • Coarse rock salt meat needs to be the same weight all the way around to ensure it turns evenly.
- Page 14 NOTES...
- Page 15 OZPIG 3-IN-1 FLAT PACK FIRE PIT INSTRUCTION MANUAL NOTES...
-
Page 16: Limited Warranty
LIMITED WARRANTY 1. Products distributed by Adventure Operations Australia Pty Ltd and any of our subsidiaries come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if products fail to be of acceptable quality and the failure does not amount to a major failure.
Need help?
Do you have a question about the OZP-FP022-01 and is the answer not in the manual?
Questions and answers