Related Manuals for Gazelle GT1400
Summary of Contents for Gazelle GT1400
- Page 1 GT1400 Marble Cutter Pictures of battery packs with different configurations vary in the illustration.
- Page 2 Read through carefully and understand these instructions before use.
-
Page 3: General Power Tool Safety Warnings
the influence of drugs, alcohol or medication. A General power tool safety warnings moment of inattention while operating power tools WARNING Read all safety warnings, may result in serious personal injury. instructions, illustrations and specifications b) Use personal protective equipment. Always provided with this power tool. - Page 4 maintained power tools. balance, vibrate excessively and may cause loss of f) Keep cutting tools sharp and clean. Properly control. i) Do not use damaged wheels. Before each use, maintained cutting tools with sharp cutting edges inspect the wheels for chips and cracks. If are less likely to bind and are easier to control.
- Page 5 Further safety instructions for abrasive cutting-off is in motion otherwise kickback may occur. operations Investigate and take corrective action to eliminate Kickback and related warnings the cause of wheel binding. h) Do not restart the cutting operation in the Kickback is a sudden reaction to a pinched or snagged rotating wheel.
-
Page 6: Technical Data
This product is widely used in interior decoration, road construction, building decoration and other civil engineering construction. The performance and specifications of this product are shown in the table below: Model GT1400 Rated Power Input 1400 Rated Speed /min 13000 Max. - Page 7 CAUTION: MAINTENANCE AND CARE This tool should only be used on horizontal CAUTION: surfaces.Be sure to move the tool forward in a Always be sure that the tool is switched off straight line and gently. Forcing and exerting and unplugged before attempting to perform excessive pressure or allowing the wheel to bend, inspection or maintenance.
- Page 8 EXPLANATION OF GENERAL VIEW Clamping Screw Insulation Washer Flange Ball Bearing Flange Washer Bearing retainer block O Ring Woodruff Key Dust Cover Drive Spindle Handle Cover Ball Bearing Switch Cover Circlip for Shaft 12 Switch Gear(Large) Pan Head Tapping Screw ST4.2×17 Cross Recessed Hex Bolt with Indentation M4×25 (with Spring Strain Relief...
Need help?
Do you have a question about the GT1400 and is the answer not in the manual?
Questions and answers