Subscribe to Our Youtube Channel
Summary of Contents for Sens UNO EVO
- Page 1 UNO EVO removable cover power cord cover release screw tamper switch buzzer cable lock screw battery case cable blocker USB-C USB-C connector 1 connector 2...
- Page 2 UNO EVO Mounting an acrylic display stand 1. Remove the cover release screw completely. 2. Turn UNO cover clockwise to remove it from the UNO controller. 3. Place the selected Display Stand (0 degrees 4. Before placing back the screw into the UNO-EVO...
- Page 3 UNO EVO Connecting charging or sensor cable 1. Release the cable lock screw and remove the cable blocker from the UNO EVO. 2. Insert the USB/C connector (charging cable or sensor cable) with the ‘ears’ directing out. 3. Place the blocker over the connector(s) and...
- Page 4 4. Clean the table / display surface. 5. Remove transparant protective foil from the adhesive. 6. Press the UNO EVO lightly on the display for 10 seconds (optimal adhesive power is reached after 24 hours). 7. Connect the USB/C connector to a power adaptor and plug it into a wall outlet.
- Page 5 UNO EVO Install the smartdisc (phone or tablet) 1. Remove protective foil from the adhesive. 2. Make sure cable output and charging port of the device face the same direction. 3. Stick the smartdisc at the back of the device...
- Page 6 UNO EVO Install the smartdisc with clamps (phone or tablet) width adjustment 1. Loosen the screws of the height and width adjustment enough to allow the device to move freely in the clamps. height adjustment 2. Find the correct position (the...
- Page 7 UNO EVO Install charging cable 1. Unscrew the screw until you feel resistance. 2. Open smart disc cover and pass the cable through cable channel. 3. Close the smart disc cover and tighten the screw. 180° connector...
- Page 8 2. When the LED of the UNO EVO ashes blue and buzzer sounds, the set-up is successful completed. 3. When the LED does not ash or buzzer does not sound, bring to SRF Key closer to the UNO EVO (as indicated in the picture) and repeat the procedure. max 4 cm...
Need help?
Do you have a question about the UNO EVO and is the answer not in the manual?
Questions and answers