Global Solutions GS1730 Operating Instructions

Cotton Candy Machines
Introduction :
1. Please read instructions before using this appliance.
2. When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
injury.
3. Clean machine thoroughly before and after each use following
the cleaning instructions provided below.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Warning! All power must be disconnected at power source
before any service procedure is performed.
2. This appliance must be placed on a level surface.
3. Do not leave this appliance unattended while it is in use.
4. Never immerse the appliance in water.
5. Keep loose clothing and other foreign objects away from the
spinning head.
6. Do not attempt to repair or replace the power cord if it is
damaged. Contact a qualified service agent.
7. Be careful not to touch any hot surfaces. Make sure the power
cord does not come into contact with any hot surfaces.
Electrical Requirements :
Refer to the product tag (serial plate) on the back of the unit for
voltage and wattage requirements. Be sure to plug unit into
grounded outlet with sufficient power.
WARNING: DURING NORMAL OPERATION, THE SPINNING
HEAD OF THE UNIT IS HOT!
Preparation
1. Remove all packing pieces and lift unit out of the box.
2. Remove any outside packaging.
3. Set unit on a flat, stable, solid surface and position it
away from any water source.
Physical Address: Corporate HQ
301 Meuse Argonne | Hicksville, OH 43526
800.782.6761 • 419.542.7751 • f: 419.542.6690
OPERATING INSTRUCTIONS
February 23, 2024
globalsolutionsfoodequipment.com
4. Position the unit near a power outlet. Avoid the
use of extension cords. Do not run cord under
carpeting or cover with runners or the like. Plug
the unit into a grounded outlet with correct voltage and
sufficient power capacity. Refer to the product label
(serial plate) on the unit for voltage and wattage
requirements.
5. Install the bowl on top of the base. Make sure the
bowl is not in contact with the heating head. Place
floss bubble shield (Optional – Sold Separately) on
top of the bowl.
Operation :
1. Plug cord into grounded electrical outlet of the correct
voltage.
Turn on the "POWER" and "HEAT" switches. Both
2.
switches will light up when turned on. Allow 2 to 3
minutes for the machine to warm up.
3. Add floss sugar directly into the well of the heated
head. Do not overfill.
4. Cotton candy will begin to spin around the bowl as the
heated head continues to spin. As the cotton candy
begins to accumulate, it will build up and come out the
top of the spinning head. The cotton candy will need
to be collected as it comes out of the top of the unit.
5. Allow the machine to cool down for 15 to 20 minutes
after an hour of continuous use.
Cleaning :
NOTE: Proper maintenance plays an important part in the
life span and functioning of the machine.
1. Always unplug the machine when not in use or when
cleaning.
2. Allow the components to cool off before cleaning.
3. Wipe down the spinning head with warm water and a
mild detergent and a non-abrasive towel. Note: For
higher volume usage, please clean the spinning head
frequently to prevent build-up of burnt sugar.
Global Solutions Distribution Center/Test Kitchen
4300 E Magnolia Street | Phoenix, AZ 85034
Model Series:
GS1730 & GS1731