Getting Started; Play A Disc - Curtis DVD DVD1072 Instruction Manual

GETTING STARTED

Unpack the unit.
Read through thisowner's manual before installation and use.
Load batteries into the remote control unit.
Connect the system,make sure the connections are secured.
Connect the power plug to the AC power outlet.

Play a disc

Switch on the player
Push the main power button to turn on the
DVD unit. Power on the TV set and the
amplifier if connected.
Load a disc
Automatic Play
The unit will take a few seconds to download
upper corner of the TV screen, and then start playing automatically .
If a DVD Disc Menu appears on screen
NOTE
Normally, when a MP3 disc is loaded, the unit will
take longer time to download the initial data.
DVD disc that does not match the region code cannot be
executed by this player.
Press EJECT button on the remote control (or front panel) to
open the disc tray. Load a disc and press EJECT to close the
disc tray
(Note, place the disc's label side up, blank side down)
EJECT
the disc initial data, display the disc type logo in the left
Press PLAY button on the remote
(or on the unit) to start playing.
or
Some features contained in this DVD player
are related to the DVD disc's software.
Some features cannot be performed if the
disc does not support The feature, or requires
special settings.
Check the features printed on the disc's
packing or follow the instructions of the Disc's
on screen menu.
.
2
Press CURSOR buttons
to select the
desired feature
in the menu,
And then
press the ENTER button
to confirm a selection.
Return to the disc main menu, press MENU button on the remote.
Prevent loading the disc upside down.
7 7
REMARK
1