Advertisement
Quick Links
Marry Shield Hand Tool
CAT-IN-B1SD-01-12
Introduction
Marry Shield Hand Tool CAT-IN-B1SD-01-12 was designed to marry SH149-XX-N with B1SDR-XX.
This tool should only be used for the shields and bodies specified on this document. The tool is not
adjustable. Variation in production batches of tools, connectors, shields, and body types may affect marry
parameters.
Marrying Procedure
1. Pre-load shield & rear body over cable assembly
2. Load pre-loaded cable into tool with cable exiting
toward the front of the tool (away from handle)
3. Squeeze the handles until the tool ratchet releases,
allowing the handles to fully open (Figure 1).
4. Unload cable and verify latch position
©Samtec, Inc.
CUSTOMER SERVICE +1-800-726-8329 (+1-812-944-6733)
Instruction Sheet
STS-M-B1SD-01-12
Rev. A
Date: 12/8/2023
Inspect latch
position after fill
Page 1
Advertisement
Related Manuals for Samtec CAT-IN-B1SD-01-12
Summary of Contents for Samtec CAT-IN-B1SD-01-12
- Page 1 Date: 12/8/2023 Introduction Marry Shield Hand Tool CAT-IN-B1SD-01-12 was designed to marry SH149-XX-N with B1SDR-XX. This tool should only be used for the shields and bodies specified on this document. The tool is not adjustable. Variation in production batches of tools, connectors, shields, and body types may affect marry parameters.
- Page 2 Instruction Sheet STS-M-B1SD-01-12 Marry Shield Hand Tool Rev. A CAT-IN-B1SD-01-12 Date: 12/8/2023 CAUTION: Should a cable become stuck or jammed in a partially closed position, DO NOT use force to open or close the handles. The tool will easily open by pushing the ratchet release lever up (Figure 2).
- Page 3 Instruction Sheet STS-M-B1SD-01-12 Marry Shield Hand Tool Rev. A CAT-IN-B1SD-01-12 Date: 12/8/2023 Adjusting the Handle Pre-Load The tool is calibrated at the factory to the optimum pre-load required to achieve a proper marry. It may become necessary, over the life of the tool, to adjust the handle pre-load force.