Advertisement
*OPTIONS:
Ten Meter
Modification
Kit
-- for
licensed
US awateurs
XPort Model,
factory built-in 10 meter band
Specificutions
are
subject
to
change
without
notice
or
obligation,
FRONT
PANEL
CONTROLS
ON-AC ROCKER SWITCH - Turns power on and off.
AMIT-STBY ROCKER SWITCH
- Turns the amp from standby to operate
mode,
RAND-SWITCH
- Selects desired bands,
PLATE AND LOAD KNOBS - Tuning adjusts Pi-Network capacitors
in
lunk circuit for proper resonance end loading on all bands.
PLATE CURRENT METER
- Continuously monitors
plate current
of 3-
SUUZ
tubes.
GRID-VOLT METER - By use of the meter switch can monitor plate
volts
(0-500
V or grid eurrent
0-350 mA,
REAR
JACKS
RF-IN - For connecting
to exciter RF output.
RF-OUT - For connecting
the LK500ZB to an antenna.
RLY
~ For conneeting to exciter auxilary
jack to ectivete T/R
Relay in the LK~500ZB,
KEY JN - QSK ONLY-station key, must be a bug, hand key or a keyer
with # reed relay.
KEY
OUT
- QS8K ONLY
- hooks
to
the
key
in
jack
on
a QSK
transceiver,
@SK VOX SWITCH - place in the QSK position when operating QSK CW,
INSTALLATION
1.
Make no attempt to put the Amplifier
in service outside of
the cabinet -- contact with voltage in this Amplifier CAN BE
FATAL
3
Advertisement
