Cleaning And Maintenance; Disposal And Recycling - EINHELL GE-SR 18/22 Li Operating Instructions Manual

opens, and the device begins to spread.
3. Insert the plug (Item 34) into the hole
provided (Item 36) to lock the On/Off switch
(Item 16).
The lock button and On/Off switch can now
be released. The device is now running in
continuous operation.
To switch off continuous operation, the plug
(Item 34) must be removed from the hole
(Item 36).
6.4 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.5 Battery capacity indicator (Fig. 21 / item
40)
Press the battery capacity indicator switch (Item
41). The battery capacity indicator (Item 40)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Anl_GE_SR_18_22_Li_SPK7_NA.indb 16 Anl_GE_SR_18_22_Li_SPK7_NA.indb 16
EN

7. Cleaning and maintenance

HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The penetration
of water into an electric power tool increases
the risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 50°F and 104°F (10°C
and 40°C). Keep the electric tool in its original
packaging.
- 16 -
09.04.2024 11:22:20 09.04.2024 11:22:20