Summary of Contents for DIP DP-30KSH
- Page 1 DP-30KSH DRY ICE BLASTER OPERATING MANUAL DIP DRY ICE PRODUCETION CO., LTD ALWAYS READ THESE INSTRUCTIONS BEFORE USE.
- Page 2 IMPORTANT ALWAYS READ THESE INSTRUCTIONS BEFORE USE. ONLY OPERATE THE EQUIPMENT AS DESCRIBED. NEVER FOOL AROUND WITH THIS EQUIPMENT AND NEVER POINT THE BLAST NOZZLE AT YOURSELF OR OTHERS. ALWAYS READ THESE INSTRUCTIONS BEFORE USE.
- Page 3 CAUTION ALWAYS KEEP THE HOPPER LID CLOSED TO AVOID MATTERS DROP OFF INTO THE HOPPER. ALWAYS READ THESE INSTRUCTIONS BEFORE USE.
-
Page 4: Essential Information
PART 1 Essential Information DP-30KSH Dry Ice Blaster Applicable to enterprises and institutions in general cleaning requirements Specifications ALWAYS READ THESE INSTRUCTIONS BEFORE USE. - Page 5 PART 2 Safety Issues The major hazards presented by the use of this equipment arise from: The use of compressed air potentially causing dangerous flying objects, debris re-circulation and inhalation and noise either through planned or unplanned release. The use of dry ice (solid carbon dioxide), a substance of extreme cold capable of causing burns and death by asphyxiation.
- Page 6 WARNING: 1. Before servicing, turn off and lockout main power disconnect and all circuits powered by an external source. 2. Do not modify circuits. 3. Earth ground machine before turn on power. 4. Additional guards, ventilation system, and other safety equipment must be required. 5.
- Page 7 PART 3 Control Panel ALWAYS READ THESE INSTRUCTIONS BEFORE USE.
-
Page 8: Operation
Blasting Operations PART 4 SET-UP 1. Connect gun with nozzle to blast hose and control cable. 2. Always connect the static strap to the item being cleaned. 3. Check the hopper is clear of debris and water. 4. Connect power cable. OPERATION 1. -
Page 9: Part 5 Maintenance
Part 5 Maintenance Although the blast unit has been designed for minimum BLAST UNIT maintenance, Clean Surface recommends the following service schedule carried regular basis to ensure trouble free operation. Daily Check Pressure gauge Bottom wheel lock Monthly Check Viabrator Hammer The screws of whole blast unit Yearly Check... - Page 10 Whenever the Blaster is used the Air Supply Hose and Blast HOSES Hose Assembly should be examined for damage and wear before start-up. THE SYSTEM MUST NOT BE STARTED IF ANY HOSES ARE DEFECT. The most critical elements are the hoses which carry compressed air.
- Page 11 Remove the Blast Nozzle from the Hose Assembly and clean BLAST NOZZLE as appropriate. Check the compressed air and dry ice inlets for any signs of wear and ensure that the removable outlet nozzle is free of any obstruction. On refitting the outlet nozzle ensure that it is fully screwed in and tight enough not to come loose in service.
Need help?
Do you have a question about the DP-30KSH and is the answer not in the manual?
Questions and answers