Simplay3 41608R-01 Assembly And Installation Instructions

Mailbox
Styles may vary
ASSEMBLY AND INSTALLATION INSTRUCTIONS
For assistance or replacement parts please contact Simplay3
The Simplay3 Company
9450 Rosemont Drive
Streetsboro, OH 44241
ENGLISH
OBSERVE THE FOLLOWING STATEMENTS AND WARNINGS TO
REDUCE THE LIKELIHOOD OF SERIOUS OR FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
WARNING:
- Choking Hazard: Small parts. Sharp points. Adult assembly required.
- Required for Installation: Standard 4"x4" post cut to 48-inch length (not included)
- Note: with normal soil conditions and level ground, a standard 4"x4" post cut into 48 inch
length is adequate for mounting your Simplay3 Mailbox with 26 inches in ground and 22
inches above ground.
- Decal Application:
Clean and dry area thoroughly. Center decal in area. Apply pressure from center to
outer edge.
- To minimize risks posed by drill shavings, screws are designed to pierce the plastic
and form their own threads. Use caution not to over-tighten screws or they will not hold
parts together appropriately.
- Cleaning Instructions:
General Cleaning: Use mild soapy water.
- Disposal Instructions:
Please recycle when possible. Disposal must be in compliance with all government
regulations.
- USA Residents ONLY: CUSTOMERS ARE REQUIRED TO CONTACT THE LOCAL
POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT
PLACEMENT AND HEIGHT AT THE STREET. GENERALLY, MAILBOXES ARE INSTALLED
AT A HEIGHT OF 41-45 INCHES FROM THE ROAD SURFACE TO EITHER THE INSIDE
SURFACE OF THE MAILBOX THAT THE MAIL IS PLACED ON BY THE CARRIER OR TO
THE LOWEST EDGE OF MAIL ENTRY (FOR LOCKED MAIL SLOT DESIGNS) AND ARE
SET BACK 6-8 INCHES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO THE
MAILBOX DOOR.
22"
Above Ground
4'
Below Ground
26"
The wood post should be approximately 22" above
ground. A 3/16" pilot hole may be drilled in post.
1
| 56241610102
®
| 1-866-855-0100
| www.simplay3.com
1
Ground Level
Note direction of
panel side
3
TOOLS REQUIRED
PARTS LIST A
A
STYLES MAY VARY
2 x 3" (7,62 CM)
2
A
- Phillips Head
- Socket Wrench
B
C
D
6 x 2" (5,08 CM)
2 x 3" (7,62 CM)
E
x2
04/13/2018