Charging of gassing batteries requiring ventilation is not supported. Uses other than those specified here are not permitted. amina S er utelukkende ment for å lade elektriske Product overview Safety instructions biler. Det er klassifisert som en Mode-3 EVSE...
Indoor and outdoor use (IP54) Innendørs og utendørs bruk (IP54) Tekniske spesifikasjoner Private and public locations (IK08) Private og offentlige lokasjoner (IK08) Wall or pole mounted Vegg eller søyle montert Min 90cm installation height Min 90cm installasjonshøyde Installation Installasjon Permanently connected...
• External circuit breaker and RCD - see page 28 • Gjør ikke endringer på komponenter eller koble til ikke-originale ladekabler. • Sørg for at nødvendige sikringer er skrudd Utstyr til installasjon av før installasjonen. • TX20 skrujern • Eksternt overstrømsvern og jordfeilvern - se side 28...
Page 6
Disassemble charger. Lift off front cover. (1) You will find a bag of installation accessories inside the charger. Remove charge unit by gently pinching and pulling the tabs at the bottom. (2) Demonter laderen. Løft av frontdekselet. (1) Du vil finne en pose med installasjonsmateriell inne i laderen.
Page 7
Mount back plate. Attach the back plate to a sturdy surface minimum 90cm above ground using the supplied 35mm screws. Optional screw holes are located at the top and bottom of the back plate. (1) Monter bakplaten. Monter laderen på en solid overflate minst 90cm over bakken med de inkluderte fire 35mm skruene.
Page 8
Install power cable. Slide the grommet down the power cable to seal the inlet-hole in the back plate. Installer strømkabel. Skyv nippelen nedover strømkabelen til den dekker inntakshullet...
Page 9
Prepare and secure power cable. Strip power cable about 10cm above the inlet hole. (1) Secure cable with the supplied cable clamp and two 12mm screws. (2) Forbered og fest installasjonskabel. Avisoler kabelen ca. 10cm over inntakshullet. (1) Fest kabelen med kabelklemmen og to 12mm skruer.
Page 10
Insert the charge unit. Insert the upper part of the charge unit under notches in the back plate. (1) Push the lower part of the charge unit toward the back plate until it clips in. (2) Sett inn ladeenhet. Sett øverste del av ladeenheten under de to hakkene i øverste del av bakplaten.
Page 11
Connect power cable. Cut each wire to length and remove 12 – 14mm of isolation. Insert into the appropriate terminals and shut all levers. Koble strømkabel. Kutt hver leder til passende lengde og avisoler 12 – 14mm. Koble til korrekt terminal og lukk låsemekanismen.
Page 12
12mm screws. (4) Installer ladekabelen. Åpne terminalene og sett inn strømlederne fra ladekabelen. (1) Skyv strekkavlasteren mot bakplaten til den står vertikalt. (2) Fest alle 6 koblinger. (3) Fest så ladekabelen til bakplaten med to 12mm skruer. (4)
Page 13
Set charging current. Set maximum amperage at the top left corner of the charge unit. Sett ladestrøm. Sett maksimal ladestrøm i øvre venstre hjørne av ladeenheten. RESET RESET CURRENT SETTINGS Note: Merk: Changes to current Endringer på settings will not take ladestrøm vil først effect until power tre i kraft etter at...
Page 14
Mount front cover. Slide the upper part of the cover under the lip at the top (1) and push in the lower section. (2) Secure the cover with two 12mm screws. (3) Monter frontdeksel. Skyv øverste del av dekselet under leppen i toppen (1) og press inn nederste del.
Page 15
Test and finish installation. Switch on the circuit breaker. Steady white light indicates correct installation. We recommend testing the charger with an applicable test tool. An overview of light indicator colors can be found in the User guide. Test og fullfør installasjonen. Skru på...
Internal RDC-DD Type-A, anbefales det å spesifisere på samsvarserklæringen at NEK 400:2022 amina S is designed with two separate switches to provide the choice of single- er anvendt med følgende merknad til avsnitt 722.531.2.3.101: or three-phase charging. The DC-protection (RDC-DD) and each switch is qualified for IEC 62955.
Other languages The latest revision of this installation guide is available in multiple languages at download.aminacharging.com Siste revisjon av denne installasjonsmanualen er tilgjengelig i flere språk på download.aminacharging.com Manufactured by: amina distribution AS Grenseveien 21 4313 Sandnes, Norway 31-00000 Rev B...
Need help?
Do you have a question about the S and is the answer not in the manual?
Questions and answers