Table of Contents
Advertisement
en PowerBoost
Programming the cooking time
Select the cooking zone and the required power
1.
level.
Touch
.
2.
a The display lights up in the cooking zone.
Use
or to select the cooking time.
3.
a The time begins to count down.
Note: You can automatically set the same cooking time
for all cooking zones. You can find more information
about this under
→ "Basic settings", Page 8.
Changing or deleting the cooking time
Select the cooking zone.
1.
Touch .
2.
To change the cooking time, touch or
3.
to .
PowerBoost
8 PowerBoost
Allows larger volumes of water to be heated more
quickly than with the power level .
This function is available for all cooking zones,
provided the other cooking zone in the same group is
not in use.
Otherwise, and flash in the display for the selected
cooking zone. is then set automatically without activ-
ating the function.
Childproof lock
9 Childproof lock
The hob is equipped with a childproof lock. This pre-
vents children from switching on the hob.
To switch the function on, switch the hob off.
Touch
for four seconds to switch on or off.
Basic settings
10 Basic settings
You can configure the basic settings for your appliance to meet your needs.
10.1 Overview of the basic settings
Display
Setting
Childproof lock
Signal tones
Automatic switch-off of the cooking zones.
Duration of the timer end signal tone
1
Factory setting
8
7.2 Timer
Enables the activation of a timer of 0–99 minutes. This
function can be used independently of the cooking
zones and other settings. It does not automatically
switch off the hotplates.
Setting the kitchen timer
Select the hotplate and touch
1.
a
beside lights up.
Use
2.
a The time counts down.
Changing or deleting the timer duration
Touch repeatedly until the display beside
1.
lights up.
or set it
To change the cooking time, touch or
2.
to .
Press
If you want to activate the childproof lock automatically
every time the hob is switched off, you can find further
information under Basic settings → Page 8.
Value
- Manual.
Automatic.
– Switched off.
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
– switched off.
-
- minutes until the appliance switches off auto-
matically.
– 10 seconds
– 30 seconds
- 1 minute
or
to select the required time.
to switch on or off.
1
1
1
twice.
or set it
1
.
Advertisement
Table of Contents
