Accurex XID Quick Start Manual

Quick Start Guide
XID Mixed Flow Outdoor Cover
• Outdoor Cover parts are shipped
separate from the fan and are
mounted in the field
• This Quick Start Guide does not
replace the Installation Operation
Manual (IOM), refer to the IOM for
more information
Parts List
• (1) Fan
• Outdoor cover kit
(2) End caps
(2) Mullions (size 27-33 only)
Side panels
(2) Size 7-24
(4) Size 27-33
Top panel(s)
(1) Size 7-24
(2) Size 27-33
Hardware kit
(1) Size 7-22
(2) Size 24-33
(1) Conduit kit
• (1) Disconnect switch (optional)
• (1) Isolator kit (optional)
• Liquid-tight conduit (supplied
by others)
Tools List
• Impact driver
• 5/16 inch nut driver
• C clamp locking pliers
Step 1 - Mount Unit to Structure
• Place unit in desired location and mount to structure
(outdoor units are horizontal base mount only)
• Isolation is recommended but not required, please use
isolation if ordered
Step 2 - Install Ductwork to Fan
• Apply sealant to duct connections
• Use holes on inlet and outlet to mount ductwork to fan
(hardware supplied by others)
• Flexible duct connectors are recommended for
mounting to the inlet and outlet of the fan
• Install fan with approximately three wheel diameters of
straight duct before and after the fan
Step 3 - Install End Caps
• TAKE CARE NOT TO DAMAGE THE FOAM TAPE ON
END CAPS
• With flanges away from the fan, align the half moon
cutouts on the end cap with screws on inlet or outlet
• Use the provided self-tapping sheet metal screws to
fasten the end cap to the fan DO NOT OVER-TIGHTEN
• Install remaining end cap on the opposite side using
provided self-tapping screws DO NOT OVER-TIGHTEN
Step 4 - Install Side Mullions (Sizes 27-33 only)
• Install left and right side mullions using (2) self-tapping
sheet metal screws per side
BOTTOM
TOP